Parts for DE06: Control Panel Parts

This right-side end cap replaces a damaged or missing trim piece to restore a clean finished edge and secure adjacent panels. Designed for direct-fit replacement to return the appliance to its original appearance and alignment. What it does:

• Covers and protects the outer edge of the appliance cabinet or trim on the right side
• Keeps adjacent panels aligned and helps prevent wobble or gaps in the trim
• Restores finished look when the original end cap is cracked, broken, or missing
• Prevents sharp exposed edges that can catch or cause snags

• Disconnect power (and water supply if applicable) before beginning any repair
• Installation typically requires basic hand tools; handle panels carefully to avoid scratching
• Use caution around sharp sheet metal and edges; wear gloves and eye protection

The Knob Clip is an OEM part for GE washing machines and dryers. This small but crucial component is designed to secure the control knob to the appliance's control panel.  

Over time, knob clips can wear out or break due to frequent use or accidental damage. When this happens, the control knob may become loose, fall off easily, or fail to engage the control panel properly, making it difficult to set the appliance to the desired cycle or function.

Symptoms of a bad Knob Clip include:

• The control knob is loose or falls off the panel easily.
• Difficulty in adjusting settings due to a loose knob.
• The knob does not stay in place or slips when turned.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

This left-side end cap replaces the damaged or worn cover on the appliance's edge, restoring a finished appearance and helping protect internal components from debris. Durable replacement to keep the cabinet edge sealed and looking right. What it does:

• Covers and protects the appliance's left end or edge from dirt and damage
• Helps maintain a finished exterior appearance after wear or impact
• Prevents small objects and debris from entering gaps beside internal components
• Supports proper alignment of adjacent trim and panels

• One left-side end cap

• Designed for direct replacement; match part orientation (left) before installing
• Remove power and follow manufacturer panel-removal instructions to access mounting points
• Handle carefully to avoid scratching adjacent surfaces; use proper fasteners if required
• If clips or screws are damaged, replace them with OEM equivalents for a secure fit

This is an H-shaped edge connector used in the dryer's power control housing area. It provides an electrical connection point between wiring harnesses or circuit boards within the control section of the dryer. Replace this connector if you notice intermittent dryer operation, loose wiring connections, or visible damage such as burnt or corroded terminals.