Parts for Frigidaire 72-3662-23-01: 08 - Control Panel Parts

Fixes oven not heating to correct temperature or overheating. This range oven thermostat regulates temperature. Moderate DIY repair for most models.

Secures the clock assembly to the control panel on your oven. Replace if clips are broken or missing to properly mount the clock. Verify fit with model number.

This lower thermostat knob lets you select and adjust the refrigerator temperature control easily and reliably. Designed to match the original control style for a clean fit and intuitive operation. What it does

• Fits onto the lower temperature control shaft to set cooling levels.
• Provides a clear tactile grip for precise temperature selection.
• Restores a missing, cracked, or worn knob so controls are usable again.
• Works with the appliance's existing control mechanism—no electrical work required.

• 1 lower thermostat knob

• Pull the old knob straight off the control shaft; press the replacement onto the shaft until fully seated.
• If the knob is brittle or stuck, gently pry with a non-marring tool to avoid damaging the control panel.
• Disconnect power to the appliance before attempting any repair if access requires removing panels.
• If the control shaft is damaged or loose, replace or repair the underlying control assembly rather than relying on the knob alone.

Secures components inside your range. Replace if the original nut is stripped, corroded, missing, or no longer holding parts firmly in place.

This upper burner retainer secures the surface burner head and helps keep the burner aligned for even flame distribution and reliable ignition. It's a small replacement part that restores proper burner positioning. What it does:

• Holds the upper surface burner head in place on gas cooktops and ranges
• Keeps the burner aligned so the flame and heat pattern are consistent
• Helps prevent burner wobble that can cause ignition issues or uneven cooking
• Compatible with original mounting points and hardware on compatible Frigidaire ranges

• One retainer — burner upper

• Disconnect gas supply and power to the appliance before working on burners; follow appliance manufacturer safety instructions
• Remove burner cap and head, replace the retainer, then reassemble in the original order
• Check burner alignment and ignition after reassembly; if you smell gas or see irregular flame, stop and inspect

This is a starter receptacle socket used in the lighting circuit of a range or oven. It holds the fluorescent lamp starter in place and provides the electrical connection needed to ignite the oven light. Replace this receptacle if the oven light flickers, fails to turn on, or the socket shows signs of burn damage or corrosion.