Parts for Frigidaire FEB27S5DBE: 03 - Control Panel Parts

This touchpad and control panel assembly replaces the user interface that lets you set oven functions, temperature and timers. Restores button responsiveness and the visible control surface so the range responds correctly to inputs. What it does:

• Provides the front user controls and membrane touchpad for selecting bake, broil, timers and other functions
• Sends user commands to the range's control board so cycles start and settings change
• Commonly replaces panels with unresponsive or stuck buttons, missing legends, or intermittent input
• Resolves control-related problems when the display or buttons do not register presses

• Disconnect power to the appliance before servicing to avoid shock or damage
• Typical installation requires removing the oven door or control housing; handle the glass and trim gently
• Avoid touching circuit traces and connector pins; ensure connectors are fully seated
• After installation, reconnect power and test all functions before reassembling trim panels

A replacement electronic clock and timer assembly that restores timed cooking, clock display and audible alerts for affected ovens. Helps return normal oven scheduling and countdown functions when the original timer/control fails. What it does:

• Replaces the oven clock/timer control that manages time display, timed bake/clean cycles and end-of-cook alerts.
• Common symptoms: no clock display, timer not advancing, timed cooking won't start or stop, or intermittent control/display behavior.
• Interfaces with the oven's control system to enable countdown timers, delay-starts and audible beeps for finished cycles.

• Always disconnect power at the breaker before starting any repair to avoid shock or injury.
• Handle the display and connector ribbons carefully; avoid pulling on wires or bending contacts.
• Verify connector fit and orientation before restoring power; recheck all wiring against the appliance wiring diagram.

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts