Parts for Frigidaire FEB27S5DSB: 03 - Control Panel Parts

A replacement electronic clock and timer assembly that restores timed cooking, clock display and audible alerts for affected ovens. Helps return normal oven scheduling and countdown functions when the original timer/control fails. What it does:

• Replaces the oven clock/timer control that manages time display, timed bake/clean cycles and end-of-cook alerts.
• Common symptoms: no clock display, timer not advancing, timed cooking won't start or stop, or intermittent control/display behavior.
• Interfaces with the oven's control system to enable countdown timers, delay-starts and audible beeps for finished cycles.

• Always disconnect power at the breaker before starting any repair to avoid shock or injury.
• Handle the display and connector ribbons carefully; avoid pulling on wires or bending contacts.
• Verify connector fit and orientation before restoring power; recheck all wiring against the appliance wiring diagram.

A replacement hex-head screw used to secure appliance regulator brackets and similar small components. Restores proper fastener fit so panels and brackets stay firmly attached. What it does

• Fastens regulator bracket and related sheet-metal components
• Provides a secure threaded connection for components where an 8-18 thread is specified
• Helps eliminate looseness or rattling caused by a missing or damaged screw
• Matches the nickel/chrome finish commonly used on interior mounting locations

• One hex head screw (8-18 x 3/8), nickel finish

• Intended for use where an 8-18 x 3/8 hex screw is specified by the manufacturer
• Tighten to snug; avoid over-torquing which can strip sheet-metal threads
• Turn off power to the appliance before accessing internal components
• If the original screw used a lock washer or threadlocker, replace or reapply as appropriate

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts