Parts for Frigidaire FEB786CESA: 02 - Control Panel Parts

This part has been discontinued and is no longer available.

This vent trim is the molded plastic exterior piece that covers and directs airflow at the refrigerator vent opening, restoring the appliance's finished appearance and proper airflow path. What it does

• Covers the vent opening to help direct cooled air into the fresh food compartment.
• Replaces cracked, broken or missing trim that causes drafts or looks unsightly.
• Helps maintain an even appearance along the refrigerator front and prevents small objects from entering the vent.
• Fits into the existing vent opening and secures with clips or screws depending on model.

• Disconnect power to the appliance or unplug the refrigerator before starting.
• Remove any mounting screws or gently release retaining clips; align the trim and snap or screw it into place without forcing.
• If clips or fasteners are damaged, replace them before completing installation to ensure a secure fit.
• Use basic hand tools; avoid sharp tools that could scratch surrounding surfaces.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Specs: 8 - 18 x 0.500

Cork and rubber spacer for ovens and ranges. Provides cushioning and spacing between components. Replace if worn, cracked, compressed, or missing.

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

Oval-head square-drive screw secures interior and exterior oven panels, brackets, and trim. Replace worn, stripped, or missing screws for secure assembly.

This part has been discontinued by the manufacturer and is no longer available.

This black washer is a small replacement fastener washer used on compatible Frigidaire laundry appliances to restore proper spacing and reduce metal-on-metal contact. It helps maintain component alignment and smooth operation. What it does:

• Provides a durable spacer between fastened parts to prevent wear and abrasion
• Helps reduce noise and vibration caused by loose or worn hardware
• Restores correct clearance for rotating or moving components
• Commonly replaced when original washer is corroded, deformed, or missing

• Disconnect power and water to the appliance before servicing
• Install in the same orientation as the original; reuse compatible fasteners only

Flat washer used to secure components in washers, dryers, and laundry centers. Replace if washer is missing, bent, or corroded during repairs.

Cork and rubber spacer for ovens and ranges. Provides cushioning and spacing between components. Replace if worn, cracked, compressed, or missing.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Mounting screw for ranges, ovens, and cooktops. Secures panels, brackets, or internal components. Replace if missing, stripped, or damaged.

Oval-head square-drive screw secures interior and exterior oven panels, brackets, and trim. Replace worn, stripped, or missing screws for secure assembly.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Specs: 8 - 18 x 0.500

Phillips pan head screw for securing panels and components in appliances. Replace missing, stripped, or corroded screws during repairs or maintenance.

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.