Parts for Frigidaire FFET2725LSB: 03 - Control Panel Parts

This is the main electronic control board that manages key appliance functions and user interface logic, restoring reliable control when the original board has failed. It replaces the unit that runs electronic commands and timing. What it does:

• Receives input from the control panel and sends signals to operate components
• Regulates timed cycles and defrost/temperature functions where applicable
• Can stop power to subsystems when a fault is detected, preventing continued operation
• Common symptoms of a failing board: unresponsive or erratic controls, blank or error display, or intermittent operation

• One main electronic control board

• Disconnect power before servicing to avoid shock or damage
• Handle board by edges and avoid static discharge; use ESD protection if available
• Verify wire harness connections match factory routing and are secure before reapplying power

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation