Parts for Frigidaire FGB557CESD: 02 - Control Panel Parts

This is a satin-finish trim piece that fits along the splasher area of a range or oven. It provides a finished appearance and helps protect the edge where the cooktop meets the backsplash. Replace this trim if it is dented, discolored, corroded, or missing, which can detract from the appliance's appearance and leave edges exposed.

This clock mounting bracket secures the oven/range clock assembly to the control panel so the timer and clock stay properly aligned and supported. It replaces a bent, broken or missing bracket to restore stable clock placement and control-panel fit. What it does:

• Provides a secure mounting point for the range/oven clock or control-timer module
• Keeps the clock/timer aligned so buttons and display sit flush with the control panel
• Prevents rattling or movement that can cause display/connectivity issues
• Helps maintain correct spacing to avoid interference with adjacent controls

• High-level replacement: remove the control panel or trim to access and swap the bracket; follow your model's service instructions
• Turn off power to the appliance at the breaker before servicing to avoid electrical shock
• Keep fasteners and surrounding parts organized during reassembly; test the clock/timer function after installation
• If plastic clips or screws are damaged, replace them with OEM equivalents for a secure fit

Oval-head square-drive screw secures interior and exterior oven panels, brackets, and trim. Replace worn, stripped, or missing screws for secure assembly.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

This 10-16 x 1-1/4 screw secures appliance panels and components, restoring proper fit and preventing loose parts. Use it when fasteners are missing, stripped, or causing rattle and misalignment. What it does:

• Fastens trim, brackets, or interior panels to restore secure attachment
• Stops rattling or vibration caused by loose hardware
• Replaces missing or damaged screws to maintain safe operation
• Matches OEM thread and length for correct fit in specified locations

• Disconnect power and empty appliance as needed before servicing
• Use the correct screwdriver or bit to avoid cam-out or head damage
• Do not overtighten; snug until parts seat to prevent striping or cracking
• Replace all matching screws for consistent fit

Mounting screw for range installations. Secures panels, brackets, or components. Replace if stripped, missing, or corroded during repairs or reassembly.

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

Hex washer head ,10-32 x 0.375. Ground

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Replacement mounting screw that secures panels, trim, and components in ranges and ovens. Needed when original screws are lost, stripped, or damaged.