Parts for Frigidaire FGEC3067MB: 03 - Control Panel Parts

A small sleeve used to support and align a shaft, pin, or lever inside the appliance. Replacing a worn bushing restores smooth, quiet movement and helps prevent accelerated wear on adjoining parts for reliable operation. What it does:

• Supports and centers a rotating or sliding shaft/pin
• Reduces friction and metal-to-metal wear to minimize noise
• Helps maintain proper alignment for consistent performance
• Common signs of wear: wobbling play, squeaks/grinding, binding, or visible cracks

• One bushing

• Disconnect power and shut off gas/water before servicing
• Note the original orientation; seat the new bushing fully and squarely
• Clean mating surfaces; inspect shafts/pins for wear and replace if damaged
• Apply manufacturer-approved lubricant only if specified by your service manual

This electrical switch restores reliable on/off control to the designated circuit in your appliance. Replacing a worn or stuck switch helps ensure lights, fans, or motors operate only when they should. What it does

• Opens and closes an electrical circuit when actuated
• Helps correct issues like a light that won't turn on/off or a component that won't run or won't stop running
• Resolves intermittent operation caused by worn contacts or a loose/broken actuator
• Addresses signs such as melted/discolored terminals or an unusually loose/tight switch feel

• 1 switch

• Disconnect power to the appliance before servicing (unplug or switch off the circuit breaker)
• Access the switch location per your model's service information
• Photograph wire positions and transfer connectors one at a time to the new switch; do not force terminals
• Secure the switch, reassemble, restore power, and test operation

This switch bushing fits the control shaft to stabilize and guide rotary switches, helping restore proper knob alignment and smooth operation. It prevents wobble and uneven contact that can cause intermittent control behavior. What it does:

• Centers and supports the control shaft to keep the switch and knob aligned
• Reduces wobble and lateral play that can make knobs feel loose or inconsistent
• Helps maintain reliable electrical contact by keeping the switch properly seated
• Commonly replaced when knobs are loose, the switch wobbles, or control engagement is uneven

• One switch bushing

• Disconnect power to the appliance before starting any repair
• Requires removing the control panel or knob to access the switch shaft; small hand tools typically needed
• Inspect the switch and knob for wear while replacing the bushing; replace worn components as needed