Parts for Frigidaire GLEB30S9FQC: 03 - Control Panel Parts

This control panel assembly replaces the front console that houses the oven/range display, buttons and user controls so you can restore responsive operation and readable status feedback. It provides a ready-to-install user interface to operate appliance functions. What it does:

• Houses display, touchpads/buttons and indicator lights for oven/range control.
• Relays user commands to the main control board so settings register correctly.
• Restores visible status and error readouts when a damaged panel prevents normal feedback.
• Commonly used when buttons are unresponsive, the display is blank or control inputs fail.

• Disconnect power at the breaker before starting; follow lockout/tagout best practices.
• Handle the display and ribbon connectors carefully; avoid sharp bends or pinching.
• Remove mounting screws and access panels per your model's service instructions to swap the assembly.

Fix an oven that won't heat, shows error codes, or has an unresponsive display. This control board regulates heating elements and oven functions.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation