Parts for Frigidaire PCFI3670AFA: Control Panel Parts

This support mounting bracket secures an internal component to the appliance chassis to restore proper alignment and stability. Replacing a worn or damaged support helps stop sagging, rattling, and uneven operation. What it does:

• Holds and stabilizes a panel, assembly, or internal component to the appliance frame
• Prevents movement that can cause vibration noise or misalignment
• Restores correct fit and clearance for adjacent parts
• Can resolve symptoms like looseness, rattling, or components that sag or shift

• Disconnect power and water before beginning any repair
• Remove panels or trim as needed to access the support; keep fasteners organized
• Inspect mating surfaces and replace any damaged fasteners or clips

This electrical harness is a factory-style wiring connector assembly that delivers power and signals between refrigerator components for reliable operation and easy replacement. What it does:

• Routes power and signal connections to components such as fans, lights, valves and control modules
• Replaces damaged or corroded wiring that can cause intermittent failures or component loss of power
• Helps restore circuits that produce symptoms like no interior lights, non-running fans, or erratic component operation
• Uses OEM-style connectors and wire routing to match original installation

• Disconnect power at the appliance breaker or unplug the unit before starting
• Match connectors and routing to the original harness; do not force connectors or pinch wires
• Secure harness away from sharp edges and moving parts; use existing clips or straps

This electronic control is the refrigerator's main control board that manages temperature, defrost, and system cycles so the appliance runs correctly and maintains safe food temperatures. Replaces a failed or unresponsive control module. What it does:

• Regulates compressor, fans, and defrost timing to maintain set temperatures
• Provides command and feedback for the front display and user controls
• Can prevent normal cooling when the board is faulty, unresponsive, or shows error codes
• Helps stop erratic cycling or continuous run conditions caused by control failure

• Always disconnect power to the appliance before starting service
• Handle the board carefully and avoid static discharge; use ESD protection if available
• Follow the appliance service manual for connector locations
• After installation, restore power and confirm normal operation and temperature control

This main electrical harness routes power and signals between components to restore reliable operation. Replaces a damaged or worn harness to eliminate intermittent power or control failures and ensure correct connector fit. What it does:

• Carries power and control signals between the appliance's control board and components.
• Restores electrical continuity when burned, frayed, or broken wires cause intermittent operation.
• Re-establishes secure plug-and-socket connections if connectors are cracked or loose.
• Helps resolve symptoms such as components not receiving power, no response from controls, or intermittent cycling.

• Disconnect power (unplug or shut off breaker) before servicing to avoid shock or injury.
• Inspect connector orientation and routing; replace like-for-like to prevent pin miswiring.
• Secure harness with existing clips or ties; avoid sharp edges and heat sources.

This rotary selector switch controls cycle selection on compatible Frigidaire appliances, restoring reliable cycle changes and control-panel responsiveness. It replaces a worn or damaged selector to help regain normal user input and cycle selection. What it does:

• Changes the control's selected cycle or setting when the dial is turned
• Re-establishes mechanical/electrical contact if the original switch is worn or intermittent
• Resolves symptoms like unresponsive or stuck cycle selection, erratic setting changes, or no-change when turning the dial
• Works as the user-interface input component between the control panel and main control board

• One selector switch (rotary)

• Disconnect power (unplug or shut off breaker) before starting any repair
• Remove control panel or console to access the switch; retain all screws and fasteners for reassembly
• Note wire locations or take a photo before disconnecting terminals to ensure correct reconnection