Parts for Ge PFDN440EL0WW: 01 - Control Panel Parts

Replaces worn, cracked, or missing dryer control knob assembly. Restores manual control of cycle and temperature settings on your dryer control panel.

Replacement badge nameplate for your dryer. This cosmetic part displays the brand logo on the control panel. Replace if faded, peeling, or missing.

This front panel assembly is the washer's exterior front cover that restores appearance and provides a secure mounting surface for controls and trim. Replacing a damaged panel returns proper fit and cosmetic finish to the machine. What it does:

• Replaces a cracked, dented, or warped front cover that affects the washer's appearance
• Provides a secure mounting surface for control components and trim pieces
• Helps maintain proper alignment of the front enclosure and access openings
• Prevents further damage from loose or broken mounting tabs

• Disconnect power and water supply before starting any repair
• Basic hand tools required; panel may be attached with screws and mounting tabs
• Transfer any brackets, clips, or hardware from the old panel
• Handle edges carefully and align tabs fully before tightening fasteners; do not force

Replace your dryer's internal wiring harness if wires are frayed, damaged, or connections are loose. Restores proper electrical flow between components.

Support ring for dryer drum assembly. Installs inside the drum housing to provide structural support. Replace if cracked, worn, or broken during repairs.

Replacement mounting screw for dryer front panel assembly. Secures front panel to cabinet. Needed when original screw is stripped, missing, or lost.

Replacement center screw that secures the control knob to the shaft on your dryer. Needed when the original screw is stripped, missing, or loose.

This SCR 8-18 AB 1/2 is a replacement silicon controlled rectifier that restores proper power control to the appliance's control circuitry, helping the unit switch and regulate current reliably. What it does:

• Controls current flow in the appliance's power/control circuit for timed or regulated output
• Replaces a failed or intermittent SCR to stop erratic cycling, no-power, or control malfunctions
• Commonly used where electronic switching or phase control is required
• Helps restore stable operation when heating or motor circuits fail to receive proper control signals

• One SCR 8-18 AB 1/2 replacement component

• Disconnect power to the appliance before inspecting or replacing electrical components
• Observe ESD precautions and handle the SCR by its body; avoid touching leads
• Verify wiring and mounting orientation match the original part before final assembly