Parts for Ge PFDS455GL1MV: 01 - Control Panel Parts

Replaces worn, cracked, or missing dryer control knob assembly. Restores manual control of cycle and temperature settings on your dryer control panel.

Replacement badge nameplate for your dryer. This cosmetic part displays the brand logo on the control panel. Replace if faded, peeling, or missing.

Replace your dryer's internal wiring harness if wires are frayed, damaged, or connections are loose. Restores proper electrical flow between components.

Communication cable that connects between washer and dryer units to transfer cycle information. Replace if cable is damaged, frayed, or missing.

Support ring for dryer drum assembly. Installs inside the drum housing to provide structural support. Replace if cracked, worn, or broken during repairs.

Replace your dryer's display board that shows cycle settings and time. Needed when the display is cracked, dim, unreadable, or completely blank.

Replacement center screw that secures the control knob to the shaft on your dryer. Needed when the original screw is stripped, missing, or loose.

This SCR 8-18 AB 1/2 is a replacement silicon controlled rectifier that restores proper power control to the appliance's control circuitry, helping the unit switch and regulate current reliably. What it does:

• Controls current flow in the appliance's power/control circuit for timed or regulated output
• Replaces a failed or intermittent SCR to stop erratic cycling, no-power, or control malfunctions
• Commonly used where electronic switching or phase control is required
• Helps restore stable operation when heating or motor circuits fail to receive proper control signals

• One SCR 8-18 AB 1/2 replacement component

• Disconnect power to the appliance before inspecting or replacing electrical components
• Observe ESD precautions and handle the SCR by its body; avoid touching leads
• Verify wiring and mounting orientation match the original part before final assembly