Parts for Ge WSM2780DAWWW: 01 - Control Panel Parts

8 - 18 x 0.31

Replacement rotary control knob for washer dryer combos. Restores manual control of temperature and function settings when original is cracked, worn, or missing.

Washer fills but won't agitate or advance cycles? The timer controls wash, rinse, and spin sequences. DIY repair typically takes 15-30 minutes.

Start button switch for dryers and washer-dryer combos. Replaces worn, cracked, or unresponsive buttons. Mounts on control panel for cycle activation.

Dryer not heating properly or overheating? This resistor regulates temperature control in your dryer. Common repair for inconsistent heat issues.

Control panel mounting bracket for washer dryer combos. Secures the control panel assembly in place. Replace if cracked, bent, or broken hardware.

Replacement timer knob for washer dryer combo units. Installs on the control panel to select cycle times. Order a new knob if yours is cracked or broken.

This is a replacement pointer for control panels and timer knobs that restores a clear, visible indicator of the selected setting. It helps you quickly see and select the correct cycle or temperature. What it does:

• Replaces a cracked, broken, faded, or missing pointer so the control position is visible
• Aligns with the control knob to show the active setting or timer position
• Improves usability when the original pointer is worn or detached
• Matches the original white/dark gray color for a clean appearance

• Always disconnect power (unplug the appliance or shut off the breaker) before servicing
• Remove the control knob as needed, then press the pointer into the control shaft or bezel until it seats
• Do not force the part; stop and verify the part number and control style
• Refer to the appliance owner's manual or a repair guide for model-specific removal steps

Right endcap for washer dryer combo units. Replaces cracked, broken, or missing endcaps on the right side of your appliance cabinet or control panel.

Secures and organizes wiring harnesses inside your dryer. Replace if wires are loose, vibrating, or damaged. Confirm fit with your model number.

Lower wire harness for washer dryer combo units. Connects electrical components in the lower cabinet. Replace if wires are damaged, frayed, or connectors broken.

Replacement mounting screw for dryer assemblies. Secures internal panels, brackets, and components. Needed when screws are stripped, missing, or damaged.

Dryer won't advance through cycles or stops mid-cycle? This timer control board restores automatic cycle progression in your washer dryer combo unit.

Seals the unused drum light opening in your dryer cabinet. Replace if missing, cracked, or brittle to contain lint and protect internal components.