Parts for Ge WSM2780TDWAB: 01 - Control Panel Parts

Replacement use and care manual for your washer dryer combo. Needed when original guide is lost, damaged, or missing. Provides operating instructions.

8 - 18 x 0.31

A replacement pan head screw used to fasten appliance panels and components. Its standard #8 coarse thread and 3/8-inch length secure trim, brackets, and small assemblies for stable operation. What it does:

• Fastens panels, brackets, and small parts in household appliances
• Replaces stripped, rusted, or missing #8-18 pan head screws
• Restores secure mounting where vibration or wear caused looseness
• Works with sheet-metal or threaded inserts designed for #8-18 screws

• Disconnect power to the appliance before beginning any repair
• Use the correct #2 Phillips or compatible driver to avoid cam-out
• Thread in straight and tighten until snug; avoid over-tightening to prevent stripping
• Keep small screws away from children and dispose of old fasteners safely

Control knob for washer cycle selection panel. Replaces cracked, broken, or missing knobs. Installs on front control panel to restore function.

Dryer not heating properly or overheating? This resistor regulates temperature control in your dryer. Common repair for inconsistent heat issues.

Control panel mounting bracket for washer dryer combos. Secures the control panel assembly in place. Replace if cracked, bent, or broken hardware.

Secures and organizes wiring harnesses inside your dryer. Replace if wires are loose, vibrating, or damaged. Confirm fit with your model number.

Replacement mounting screw for dryer assemblies. Secures internal panels, brackets, and components. Needed when screws are stripped, missing, or damaged.

This ring drain hose is the replacement drain tube that routes and removes water from the appliance, restoring proper drainage and preventing leaks or standing water in the wash area. Designed to match the original fit and function. What it does:

• Channels wastewater from the tub/pump to the household drain to maintain normal drain cycles
• Restores proper drainage when the original hose is cracked, kinked, or leaking
• Helps prevent leaks and water damage caused by failed or deteriorated hoses
• Compatible with compatible stock mounting points for a like-for-like replacement

• One ring drain hose (1 piece) as pictured

• Disconnect power and water supply before servicing to avoid shock or flooding
• Inspect adjoining clamps and fittings; replace clamps if corroded or damaged for a secure seal
• Ensure hose routing is free of sharp bends or kinks and is secured per the appliance's service instructions

Secures the drain pump hose connection on your washer. Replace if you notice leaks around the pump or loose hose fittings. Verify fit with your model.

Dryer won't advance through cycles or stops mid-cycle? This timer control board restores automatic cycle progression in your washer dryer combo unit.