Parts for Ge ZDP484NGT1SS: Control Panel Parts

This stainless steel control panel trim restores the finished look around your appliance's control area and helps protect the controls from spills, splashes, and everyday wear. It matches OEM fit and finish for a clean, factory appearance. What it does:

• Replaces a scratched, dented or bent control panel bezel to improve appearance
• Protects the control cluster from spills and light impact
• Keeps buttons and display edges properly framed to maintain normal operation
• Fits around the control area to restore proper alignment and sealing

• Disconnect the appliance from power (and gas, if applicable) before starting any repair
• Basic hand tools are typically required; access usually gained by removing the control panel or outer cabinet trim
• Handle the bezel carefully to avoid scratching the finish during install
• If mounting hardware or clips are damaged, replace them with OEM parts for a secure fit

Stainless steel #8-18 x 3/8" screw secures panels, brackets, and components in ranges, cooktops, and ovens. Replace if stripped, missing, or corroded.

Replacement mounting screw that secures the thermostat assembly to your range cabinet. Replace if stripped, missing, or damaged during repair work.

This display harness connects the cooktop/oven control panel to the main control board so the user interface and display receive power and signals. Replacing a damaged harness restores reliable communication between the keypad/display and the control electronics. What it does:

• Carries power and signal wiring between the control board and the console/display assembly
• Restores display illumination, touchpad or button response, and control feedback when wiring is damaged
• Stops intermittent or lost functions caused by frayed, corroded, or broken connector wires
• Prevents shorting or electrical faults from exposed or pinched wiring

• One display harness

• Disconnect power (unplug appliance or shut off breaker) before starting any repair
• Handle connectors gently; align pins before seating to avoid bent terminals
• Route harness along original clips and channels to prevent pinching or heat exposure
• Test the console functions before reassembling trim and covers

This housing transceiver is the outer mounting enclosure that secures and protects the appliance's transceiver assembly, helping maintain reliable signal and control communication. It replaces cracked or broken housings to restore proper fit and protection. What it does:

• Holds and protects the wireless/transceiver module and related wiring from physical damage
• Helps maintain proper alignment and connection to the appliance control assembly
• Common symptom: damaged or cracked housing that exposes electronics or prevents secure mounting
• Common symptom: intermittent signal or communication issues when the transceiver is loose or misaligned

• One housing transceiver

• Disconnect power to the appliance before beginning any repair to avoid shock or component damage
• Handle the transceiver and circuit connections carefully to avoid bending pins or ESD damage
• Installation typically requires removing the control console or access panel and a few fasteners; keep track of screws and gaskets