Parts for Ge ZGU366LP3SS: 02 - Control Panel Parts

Size: 8 - 32 inch.

This LED board is the refrigerator interior light assembly that restores bright, even illumination inside the fresh-food compartment for easier visibility and safer food access. What it does

• Powers and distributes LED light to illuminate the refrigerator interior
• Replaces a failed or dimming light board to stop flicker or complete loss of interior lighting
• Ensures even light coverage across the compartment for better visibility
• Works with the refrigerator's existing light housing and connectors to restore normal operation

• One LED board

• Disconnect power to the appliance before starting any work
• Handle the board by its edges and avoid touching LED components or circuitry
• Remove shelves and trim as needed to access the light housing; keep track of screws and retainers
• Reconnect all wiring and verify proper operation before reassembling the compartment

A small adhesive MG logo emblem that restores the original appearance of your appliance. This peel-and-stick badge replaces a worn, faded or missing logo to keep the exterior looking factory-fresh. What it does:

• Cosmetic replacement for a missing, scratched or faded MG emblem
• Adheres to control panels, doors or trim where the original badge was located
• Restores brand identification and a finished appearance to the appliance
• Simple adhesive design avoids the need for fasteners or tools

• Clean and dry the mounting surface before applying to ensure good adhesion
• Peel backing and press firmly in place, aligning carefully before contact
• Avoid repositioning once attached; removal may damage the emblem or finish
• For safety, disconnect power before working near electrical controls or panels

This control knob lets you select burner or oven settings on your range or cooktop. It fits onto the control shaft; replacing a cracked or stripped knob restores a secure grip and accurate setting selection. What it does:

• Attaches to the valve/switch shaft to turn the surface burner or oven control
• Provides a clear pointer and comfortable grip for setting selection
• Common symptoms: cracked housing, stripped insert, loose/wobbly knob, or the knob falls off

• One control knob assembly

• Disconnect power and let the appliance cool; shut off gas if required by your model's manual
• Pull the old knob straight off the shaft—do not pry or twist the shaft
• Align the flat/keyed side of the new knob with the shaft and press straight on until fully seated
• Verify pointer alignment and smooth operation through all settings

This lens bezel covers and protects the appliance's front control panel, keeping buttons and displays visible while shielding them from spills and wear. It restores the appearance and function of the control area for a clean, readable interface. What it does:

• Protects the control panel lens and underlying electronics from splashes, spills, and everyday wear
• Provides a clear viewing surface for display readouts and button labels
• Helps keep button/dial areas aligned and prevents debris from entering gaps
• Restores a worn, cracked, or scratched control area to improve usability and appearance

• One lens bezel

• Remove power to the appliance before beginning any work to avoid shock or injury
• Typically secures with clips or screws; handle the lens gently to avoid cracking
• Inspect surrounding trim and gaskets during reassembly; replace damaged fasteners as needed

This is a stainless-steel machine screw used to secure components in appliances. Its #8-18 thread and 3/8" length provide a reliable, corrosion-resistant fastening where a short machine screw is required. What it does:

• Fastens panels, brackets, or small assemblies with a #8-18 threaded hole
• Resists rust and corrosion in humid appliance compartments
• Provides a short, secure hold where space is limited
• Compatible with standard #2 Phillips or compatible driver bit for installation

• Power off and unplug the appliance before servicing
• Use the correct driver to avoid stripping the head
• Do not overtighten; stop when snug to avoid thread or component damage
• If replacing multiple fasteners, reuse only the same size and type