Parts for Ge JB655SK9SS: Control Panel Parts

The control panel End Plate (Left) is an OEM part for GE electric ranges. It forms a barrier along the back left edge of the control panel area providing structural reinforcement and protection.

Over time, end plates can sustain damage due to normal wear and tear of using range buttons/dials daily as well as impacts from accidental bumps. Causes may include operation fatigue plus occasional mishandling.   

Causes of a bad end plate include:

• Dents, scratches or cracks in the protective barrier surface
• Loosened mounting fasteners holding it securely  
• Reduced control panel integrity and rigidity over long use
• Exposure of fragile internal electronics to potential damage

This exact GE replacement part also fits Hotpoint, RCA and select Kenmore models.

Right-hand end panel for electric ranges. Covers and protects the side of your range. Replace if cracked, scratched, or damaged for a clean appearance.

Secures the console assembly to your electric range, keeping the control panel aligned and stable. Replace if bracket is bent, broken, or missing.

Fixes loose or damaged console backs exposing wiring. This control panel back cover protects electronics and supports the range console structure.

If your electric range oven won't heat, maintains incorrect temperature, or displays error codes, the oven control board may be faulty. Moderately difficult repair requiring basic tools and careful handling.

Replace worn, faded, or peeling control panel graphics on your electric range. This faceplate overlay restores labeled button indicators and markings.

This rotary switch turns with the control knob to open and close circuits that command your appliance's function. A worn or failed switch can cause a control to stop responding, work intermittently, or not hold its setting.

• Provides on/off or multi-position control for the selected function
• Restores proper response to the matching control knob
• Common failure signs include non-responsive control, intermittent operation, or inability to change settings
• Electrical parts should be handled with power disconnected

• Disconnect power before servicing; verify no voltage is present
• Note wire positions or take a photo before removal
• Transfer knob shaft orientation and mounting hardware from the original if reusable
• Do not overtighten mounting fasteners; test operation before reassembly

Fix burners stuck on high or won't adjust temperature with this infinite control switch. Controls dual-element burner heat settings. 30-min DIY fix.

Replacement control knob for electric range surface burners. Attaches to infinite switch to control heat settings. Needed when original is cracked, broken, or missing.

Range indicator light signals when heating elements are active. Replace when light fails to illuminate or is damaged to restore visibility and safety.

Fix a dim or unprotected oven light with this range light lens. Replaces cracked or broken protective glass covers. Simple 10-minute installation.

Burners not responding to controls? This cooktop wiring harness connects surface burner switches to restore proper operation. Moderate DIY repair.