Parts for Jenn-Air JJW8627CAB: 02 - Control Panel Parts

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Electronic clock control for the oven/range. This board drives the display and manages bake/broil commands, restoring accurate timekeeping and dependable oven controls when the original control has failed.

• Governs oven operations by processing keypad inputs and signaling the heating circuits for bake and broil
• Displays clock, timer, and status information
• Monitors system feedback and can trigger fault alerts when issues are detected
• Common failure signs: blank or flickering display
• Oven won't start, won't respond to settings, or shows recurring control fault codes

• Disconnect power at the breaker and verify no voltage before servicing
• Use anti-static precautions; handle the board by the edges
• Note wire/connecter locations and transfer them one at a time; reuse any brackets/trim your model requires
• After installation, set the clock and run a test bake/broil; clear stored codes if applicable

Color: Black. For biscuit order 98008169. For white order WP98008544.