Parts for Jenn-Air SVE87600W: 04 - Control Panel Parts

This hex-head sheet metal screw secures appliance panels, brackets, and trim for a tight, rattle-free fit. Replace missing or stripped fasteners to keep covers and components firmly in place and restore proper alignment.

• Fastens sheet-metal parts, brackets, and trim using a hex drive
• Replaces worn, rusted, missing, or stripped screws
• Helps reduce vibration and rattling from loose panels
• Common signs you need this fastener: head or threads stripped, screw won't tighten, panel or handle coming loose

• Unplug the appliance before service; turn off water supply if working near water lines
• Use the correct nut driver or socket to avoid rounding the head
• Replace one fastener at a time to maintain alignment; do not overtighten
• Match screw type/length to the original location as specified by the manufacturer

This meat probe harness connects the oven's meat probe to the control board so the appliance can read internal food temperature and complete probe-based cooking cycles. It restores a secure electrical path for accurate probe readings. What it does:

• Provides the wiring and connector needed to link the oven meat probe to the control assembly
• Enables the oven to detect probe temperature for timed cooking and doneness alerts
• Replaces damaged, frayed, or corroded probe wiring that causes intermittent or no temperature readings
• Helps resolve probe error messages or failed probe detection that prevent probe-based bake/roast functions

• Disconnect power to the appliance before installing to avoid shock or damage
• Handle connectors gently; ensure a secure, fully seated connection at both probe and control ends
• Route and secure wiring clear of heating elements and sharp edges to prevent future damage

This wiring harness connects the refrigerator cooling/condenser fan motor to the main wiring, restoring power and signal flow so the fan can run and help maintain proper cooling. Simple replacement when the old harness is damaged. What it does

• Provides the electrical connection between the cooling/condenser fan motor and the appliance wiring.
• Replaces a damaged, melted or corroded harness that can cause the fan to stop running.
• Helps resolve symptoms such as a warm refrigerator/freezer, intermittent fan operation, or no fan noise when compressor is running.
• Ensures secure, correct plug-and-play connections when installed properly.

• One cooling fan wiring harness

• Always unplug the appliance or turn off power at the breaker before starting work.
• Disconnect the old harness connectors from the fan motor and cabinet wiring; note routing and securement before removal.
• Reconnect new harness making sure all plugs seat fully and any retaining clips or ties are re-used to prevent contact with moving parts.
• After installation, restore power and verify the fan runs and there are no abnormal noises.