Parts for Kenmore 790.41399400 (79041399400, 790 41399400): Control Panel Parts

Replace your wall oven's control panel assembly if the touchpad is cracked, unresponsive, or worn. Restores the control interface appearance and function.

This control panel assembly replaces the front console and user interface on compatible Frigidaire ranges and ovens, restoring button and display function so you can set controls and oven modes reliably. What it does:

• Houses the front touchpad/buttons and display used to select bake, broil, timer, and other functions
• Re-establishes user input when buttons are unresponsive, sticky, or the display is blank or garbled
• Routes signals to the oven control board so selected cycles and temperatures start as intended
• Helps resolve symptoms like non-working keys, missing clock/timer readout, or failure to register commands

• One control panel assembly (console) as shown

• Always disconnect power at the breaker or unplug the appliance before servicing
• Installation typically requires removing the back or top of the console and unplugging a wiring harness; handle the display and overlay carefully to avoid damage
• Keep screws and grounding hardware for reassembly; verify connector seating before restoring power

Wall oven not heating, display blank, or buttons unresponsive? This control board regulates all oven functions. Moderate DIY repair with basic tools.

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

A replacement hex-head screw used to secure appliance regulator brackets and similar small components. Restores proper fastener fit so panels and brackets stay firmly attached. What it does

• Fastens regulator bracket and related sheet-metal components
• Provides a secure threaded connection for components where an 8-18 thread is specified
• Helps eliminate looseness or rattling caused by a missing or damaged screw
• Matches the nickel/chrome finish commonly used on interior mounting locations

• One hex head screw (8-18 x 3/8), nickel finish

• Intended for use where an 8-18 x 3/8 hex screw is specified by the manufacturer
• Tighten to snug; avoid over-torquing which can strip sheet-metal threads
• Turn off power to the appliance before accessing internal components
• If the original screw used a lock washer or threadlocker, replace or reapply as appropriate

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.