Parts for Kenmore 790.41399403 (79041399403, 790 41399403): Control Panel Parts

Wall oven not responding to buttons or displaying error codes? This electronic control board restores proper operation and timing control.

This repair parts list is the factory parts diagram and item list used to identify service parts and part numbers for repair. It helps you find the exact parts shown in exploded diagrams so you can order or reference replacements. What it does:

• Shows exploded diagrams and itemized part numbers for service and ordering
• Helps identify broken, missing, or worn components by name and position
• Clarifies part quantities and assembly relationships for accurate ordering
• Useful for technicians and DIYers to confirm part fits before purchase

• This document is for identification and reference; it is not a replacement hardware part
• Follow appliance safety guidance and disconnect power before servicing
• Use the parts list together with the service manual or schematic when available

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

Wire harness for electric wall ovens. Connects electrical components within the oven cavity. Replace if wires are frayed, damaged, or connectors are broken.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation