Parts for Maytag JDS9860CDS01: 03 - Control Panel Parts

Note: This part does not include the control board. It does include the membrane switch (touchpad) along with the panel. 

Color: Stainless Panel w/Black Membrane

This product is a Whirlpool oven control "panel" assembly. This is a genuine OEM product and is sourced directly from Whirlpool. This part is compatible with Whirlpool, Magic Chef, Admiral, and Maytag appliances.

Color: Black. For biscuit order 98008169. For white order WP98008544.

This control knob replaces a worn or missing dial so you can reliably select settings on your appliance. Restore smooth, positive control and a like-new look when an old knob cracks, strips, wobbles, or falls off.

• Attaches to the control shaft so you can choose functions, temperatures, or speeds
• Provides a secure grip for accurate adjustments
• Typical symptoms include a cracked or missing knob, loose or wobbly feel, spinning without engaging, or difficulty turning to Off
• Direct replacement designed to fit the original control stem on compatible models

• Turn the appliance off and allow any hot surfaces to cool
• Pull the old knob straight off the control shaft; avoid prying against the console
• Align the new knob with the shaft and press straight on until fully seated
• Test operation to ensure the pointer aligns with Off and the control engages properly

This electronic control board is manufactured by Whirlpool. The control board acts as the heart of the oven and allows the user to adjust temperatures, change cooking modes, and more. Without a functioning control board, the oven will not operate, so replacement when it fails is essential. The electronic control board is installed beneath a protective covering, so the chance of damage is reduced, but not eliminated. Exposure to heat, spilled liquids, impacts with solid objects, and simple wear due to use can all lead to an inoperable control board. This may present as intermittent operational problems, or the board could be completely inoperable. Replacing the electronic control board will require first turning off the power to the oven, then removing the metal cover/surround. Six screws hold the control board in place and will need to be removed. The replacement follows the same steps in reverse order. This is a genuine OEM replacement, directly from the manufacturer. It is sold individually. This electronic control board is compatible with equipment from Whirlpool and Jenn-Air.

This sheet-metal pan-head screw secures appliance panels, brackets, and components to the cabinet or frame. Replacing a missing or damaged screw restores a tight fit and helps stop rattles, misalignment, and loosening.

• Fastens sheet-metal panels, covers, ducts, and brackets to the appliance chassis
• Helps keep components aligned and secure during operation
• Replace if the original is missing, rusted, stripped, or damaged
• Common symptoms: loose or vibrating panels, gaps or misaligned parts, hardware that won't tighten

• Disconnect power; shut off gas or water supply before servicing
• Support the panel or part being attached; hand-start threads to avoid cross-threading
• Use the correct driver bit; tighten snugly but do not overtighten into sheet metal
• If multiple matching screws secure a part, consider replacing them as a set for consistent hold

A shoulder screw that secures appliance components and provides a precise pivot or spacer point. Replaces a missing or worn screw to restore alignment, reduce rattling, and keep panels and assemblies securely in place. What it does:

• Provides a fixed-diameter shoulder for pivots, spacers, or mounting points in assemblies.
• Holds panels and moving components at the correct distance to prevent binding or friction.
• A missing or worn shoulder screw can cause misalignment, rattling, or loose parts during operation.
• Used where a smooth-bearing surface and controlled clearance are required between parts.

• Disconnect power to the appliance (unplug or shut off breaker) before servicing.
• Handle small fasteners carefully to avoid dropping into assemblies; magnetic pickup tools can help.
• Start threads by hand to avoid cross-threading; tighten snugly but avoid overtightening.