Parts for Speed Queen SSG909LF: Control Panel Parts

This is a hybrid switch mounting assembly that includes the push-to-start switch and its mounting hardware for a dryer. The switch completes the circuit to begin the dryer cycle when pressed. Replace this assembly if the dryer does not start when the button is pushed, or if the switch feels loose, stuck, or unresponsive.

Fix a dryer that won't start, has unresponsive controls, or cycles that won't advance. This electronic control assembly restores reliable operation.

This front cabinet section assembly replaces a damaged or worn front panel on compatible commercial-style washers, restoring structural support and proper alignment for the door and control components. What it does

• Replaces the washer's front cabinet panel to restore structural integrity and mounting points.
• Supports the door, latch and lower trim to ensure proper opening and closing.
• Helps stop rubbing or gaps caused by a bent or damaged front section.
• Restores secure attachment points for controls and console components.

• Disconnect power and water supply before beginning work; follow all safety precautions.
• Installation typically requires removing the console, door and related trim to access mounting points.
• Use appropriate fasteners and alignment shims; check fit and door operation before final tightening.
• If seams or sheet-metal damage is extensive, inspect surrounding structural parts and replace as needed.

This switch knob fits onto the control switch shaft so you can select settings and operate the machine. Replacing a cracked, stripped, or missing knob restores smooth, reliable control and keeps daily use straightforward. What it does:

• Fits over the control switch shaft to turn the switch and choose settings
• Restores a secure grip and clear position when selecting options
• Helps resolve issues like slipping when turning or a knob that won't stay attached
• Common symptoms: cracked knob, stripped insert, loose or missing knob, difficulty selecting settings

• 1 switch knob

• Disconnect power before servicing
• Pull the old knob straight off; remove any retaining clip or set screw if present and save it
• Align the flat/D-shaft orientation and press the new knob fully onto the switch shaft
• Test the switch through all positions to confirm proper engagement