Parts for Thermador POD30101: Control Panel Parts

Replaces cracked or damaged outer control panel on your wall oven. Covers front control area, secures buttons and knobs. Restores clean appearance.

Replacement light lens cover for wall ovens. Protects the interior bulb and provides illumination. Replace if cracked, discolored, or missing.

Fix unresponsive or stuck oven controls with this round control panel push button. Restores tactile input when buttons are worn, cracked, or missing.

Mounting plate for electric wall ovens and oven/microwave combos. Replaces cracked, bent, or missing plates. Secures oven unit to cabinet opening.

Replace a cracked, broken, or missing control knob on your wall oven. This knob installs on the control panel to operate temperature settings.

Trim plate for wall ovens and oven/microwave combos. Covers installation gaps between unit and cabinet cutout. Replace if cracked or damaged.

Wall oven not heating or display not working? This cable harness connects electrical components. Common fix for power issues. DIY repair in 30-45 minutes.

Wall oven not powering on or display blank? This cable harness restores electrical connections. Moderate DIY repair taking 30-45 minutes.

This cable harness is the factory-style wiring assembly that routes power and signals between appliance components to restore reliable electrical connections and control communication. What it does

• Carries power and control signals between the control board, sensors, and actuators.
• Replaces damaged or burnt wiring that can cause intermittent operation or loss of function.
• Helps resolve symptoms such as no power to components, erratic behavior, or fault codes related to open/short circuits.
• Maintains correct wire routing and connector fit for safe, stable operation.

• Disconnect power at the breaker or unplug the appliance before starting any work.
• Compare the replacement harness to the original to confirm connector types and lengths before installation.
• Route the harness along original paths and secure with existing clips or ties to avoid heat or pinch damage.

This cable harness connects key electrical components to restore power and signal flow in the appliance. It replaces a damaged or faulty wiring harness to help return controls and components to normal operation. What it does:

• Carries power and control signals between the control board and components
• Replaces frayed, burned, or broken wires that cause intermittent or no operation
• Common symptoms it can address: appliance won't start, controls unresponsive, intermittent cycles, or error codes related to open/shorted circuits
• Helps ensure secure connector mating and correct signal routing when installed properly

• Disconnect power at the breaker or unplug the appliance before starting any repairs
• Compare the new harness to the old one and follow the appliance wiring diagram for correct routing and connector placement
• Secure connectors fully; avoid sharp bends or pinching the wires during reassembly

Wall oven not heating or displaying errors? A faulty cable harness often causes electrical failures. This internal wiring assembly typically requires 1-2 hours to replace with moderate skill.

Mounting screw secures internal oven components and panels. Replace if stripped, missing, or damaged during service. Essential hardware for reassembly.