Parts for Whirlpool GBD279PVS00: 06 - Control Panel Parts

This control panel assembly provides the user interface and housing for oven/range controls, restoring button access, display visibility, and function selection so the appliance responds correctly to settings and commands. What it does:

• Replaces the front control interface and bezel so buttons, touchpads, and the display operate reliably
• Restores visible readout and selector feedback when the original panel is cracked, faded, or malfunctioning
• Addresses symptoms such as unresponsive controls, missing or dim display segments, or cosmetically damaged panels
• Acts as the mounting surface for buttons, switches, and electronics that communicate with the control board

• One control panel assembly (black) as shown

• Disconnect power (unplug or shut off breaker) before starting any repair
• Remove backguard or console trim per service manual to access mounting screws and harness connections
• Handle the panel and any display lens carefully to avoid scratching or damaging the keypad/overlay

This membrane switch touch pad replaces a worn or unresponsive control panel interface so you can restore reliable button response and regain normal oven/range control. It provides a direct user interface for selecting functions and settings. What it does:

• Registers user button presses on the oven/range control panel so the appliance accepts commands
• Replaces damaged, faded, or unresponsive keys that stop cycles from starting or changing settings
• Can correct intermittent or non-working touchpad behavior caused by wear or surface damage
• Works with the existing control housing and ribbon/connector to send signals to the control board

• One membrane switch touch pad

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Handle the flex ribbon and contacts carefully; avoid bending or creasing the conductor area
• Align the switch properly in the control housing and reconnect the ribbon/connector securely
• Test function with power restored before fully reassembling the control panel

This latch sister board controls the oven's motorized door lock used for self-clean and safety interlock functions. Replacing a failed board restores reliable lock/unlock operation so your oven can start cycles and complete cleaning as designed.

• Powers the door-latch motor when commanded by the main control
• Engages or releases the door lock during self-clean cycles
• What's included: One latch sister board.

• Disconnect power at the breaker before servicing
• Use ESD protection and handle the board by the edges
• Access is typically behind the control/upper panel; photograph wiring and transfer connectors one at a time
• After reassembly, verify latch operation before running a full self-clean