Parts for Jenn-Air JMDFS24HM0: Control Panel Parts

Fastener screw

This wire harness connects and routes electrical signals between components so controls, motors and sensors receive power and communication. Replacing a damaged harness restores safe electrical continuity and reliable operation. What it does:

• Links control board, switches and motors with insulated wires and connector plugs
• Replaces frayed, burnt or broken wiring that can cause intermittent operation or failures
• Restores proper signal and power flow to affected appliance circuits
• Helps eliminate arcing, shorts or error codes caused by damaged wiring

• One complete wire harness assembly as shown

• High-level replacement only; disconnect power before servicing and follow appliance-specific wiring diagrams
• Handle connectors carefully to avoid bending pins; match connector orientations during reassembly
• If connectors or terminals are corroded, replace or clean per OEM guidance

This console is the outer control panel assembly that houses the dryer or washer controls and display, restoring a finished appearance and providing a secure mounting location for the user interface. Designed to match the original OEM fit and function. What it does:

• Replaces a cracked, faded, or damaged control panel shell to restore proper button and display alignment.
• Provides the mounting surface for user controls, buttons, and the display window so settings operate correctly.
• Helps protect internal control components from dust, moisture, and wear caused by regular use.
• Can resolve issues where physical damage prevents normal operation or makes controls difficult to access.

• One console (control panel assembly)

• Disconnect power (and water supply for washers) before starting any repair to avoid shock or injury.
• Remove outer cabinet/console trim as required to access mounting screws; handle the console carefully to avoid scratching the finish.
• Verify alignment of clips and screw holes before tightening; avoid overtightening to prevent cracking.
• If console contains electronic components, handle with ESD precautions and avoid contact with circuit boards or connectors unless replacing the full assembly.