Parts for Maytag MHW5500FC1: 04 - Control Panel Parts

Color: Chrome Shadow
 

Color: White
 

Color: Chrome Shadow

The Dispenser Handle is an OEM part for Whirlpool washers. It is the plastic component located on the detergent dispenser drawer that allows the user to open and close the drawer access flap. 

Causes of a bad dispenser handle include cracks or breaks caused by excessive force when opening/closing over many uses. The plastic material can also become brittle or warped from long sun/heat exposure. 

Symptoms of a damaged handle include:

• Loose or dangling dispenser door that does not stay securely closed
• Difficulty opening or closing the dispenser drawer  
• Cracks along the handle surface

This genuine Whirlpool OEM handle is also a direct replacement for Maytag, Kenmore and select KitchenAid models as well.

Color: White
 

This control knob attaches to the appliance's control shaft so you can select settings with a solid, positive feel. Replace a cracked, stripped, or missing knob to restore smooth operation and a clean, finished look.

• Attaches to a switch or valve shaft to select temperatures, burner levels, or cycles
• Transfers your hand turn to the control shaft for accurate setting changes
• Common symptoms: cracked hub, spins without engaging, wobbly/loose, falls off, or missing
• Helps maintain a uniform appearance across the control panel

• Disconnect power (and shut off gas, if applicable) before servicing
• Pull the old knob straight off the shaft; avoid prying against the control panel
• Align the insert with the shaft's flats or splines and press straight on until fully seated
• Match position- and finish-specific knobs to the original on models that use different knobs per location

This is a replacement screw designed to work with a wide range of household appliances. It is used for many purposes in these appliances, from holding body panels together to securing electronics into control boards. However, screws are subject to damage through corrosion, impact, and improper installation/removal. In most cases, the primary damage to this screw is through corrosion – it may become rusted or corroded in place, depending on the appliance and the maintenance provided during its lifespan. The screw may also be stripped or rounded due to improper removal or installation. If the screw is damaged, lost, or corroded in place, it will need to be replaced. In most cases, removal will require nothing more than a Phillips head screwdriver or the appropriately sized socket with a ratchet. However, if the screw is damaged, it may require a tap set to remove it from its mounting location. Note that this is a genuine OEM replacement screw made from durable, high-quality metal, and is sold individually. It fits Whirlpool, Maytag, Roper, Estate, Amana, Crosley, and Thermador appliances. It is used in over 150 machines, ranging from washers and dryers to air conditioners.

This wire harness is the factory-style electrical assembly that routes power and signals between control components for safe, reliable appliance operation. It replaces a damaged or worn harness to restore electrical connectivity. What it does:

• Provides bundled wiring and plug connections between control boards, switches, and components
• Restores reliable power and signal paths when wires are broken, burnt, or connectors are damaged
• Helps stop intermittent operation, unresponsive controls, or components that won't power on
• Maintains proper routing and strain relief to reduce chafing and short risks

• Disconnect all power (unplug or switch off breaker) before starting any work
• Match connector shapes and routing to original harness; do not force connectors
• Secure harness with existing clips or ties and keep wiring clear of sharp edges and high-heat areas