Parts for Whirlpool WFE775H0HV5: Control Panel Parts

Color: Black Stainless

Color: Stainless

Burner won't heat or stuck on one temperature? This infinite switch controls your range surface element heat levels. DIY repair restores precise cooking.

Burner stuck on high or won't adjust temperature? This infinite switch controls heat levels for surface elements. Common DIY fix, 15-30 minutes.

If your burner won't heat, stays on high, or only works on low, replace the infinite switch. Simple 20-minute DIY repair with just a screwdriver.

Replace a cracked, broken, or missing control knob on your electric range. This knob installs on the control panel to operate burners or oven settings.

Replace a cracked, broken, or missing surface element control knob on your electric range. This knob installs on the control panel for turning burners on and off.

Heat shield for electric ranges. Protects components from heat damage. Replace if cracked, warped, or missing to restore proper heat protection.

Secures panels and components on your range. Replace if original screw is stripped, missing, or damaged to restore proper fit and eliminate rattling.

Protective cover that conceals your range's control box and wiring. Replaces cracked, broken, or missing covers to restore a finished look.

Secures the control console assembly to your range, keeping the control board and interface stable. Replace if bracket is cracked, broken, or missing.

Fix error codes, unresponsive controls, or display issues with this range electronic control board. Moderate DIY repair requiring basic tools.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal