Parts for Whirlpool WFES3330RZ0: Control Panel Parts

This stainless-steel console panel replaces the front control surface on your range/oven to restore appearance and protect the electronic controls. It provides the finished faceplate and mounting area for the control assembly. What it does:

• Covers and protects the electronic control area from spills, heat, and everyday wear
• Provides the mounting surface and openings for control buttons, touchpads or knobs
• Restores a clean, finished appearance when the original panel is scratched, dented, or corroded
• Helps prevent exposure of internal electronics that can lead to further component damage

• Disconnect power to the appliance before servicing to avoid shock or injury
• Removal may require access to the control assembly and careful detachment of mounting screws and wiring harnesses
• Handle edges carefully to avoid cuts and protect the finished surface from scratches
• Refer to the model-specific service manual or parts diagram for disassembly steps and wiring reconnection

If your burner won't heat, stays on high, or only works on low, replace the infinite switch. Simple 20-minute DIY repair with just a screwdriver.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Heat shield for electric ranges. Protects components from heat damage. Replace if cracked, warped, or missing to restore proper heat protection.

This machine screw is used across appliances to secure brackets, covers, and internal components. Replacing a missing or stripped fastener helps keep parts aligned and tight, reducing vibration and preventing loose or shifting assemblies.

• Provides machine-thread fastening for panels, brackets, and internal parts
• Helps eliminate rattling, vibration, and loose fits
• Restores proper attachment when the original screw is stripped, missing, or corroded
• Used wherever an 8-32 screw is specified in the service manual or parts list

• Disconnect power to the appliance; turn off gas/water if applicable
• Match the screw to the original location to confirm size and thread
• Start threads by hand to avoid cross-threading; use the correct driver
• Tighten snugly—do not overtighten to prevent stripping or cracking

Protective cover that conceals your range's control box and wiring. Replaces cracked, broken, or missing covers to restore a finished look.

Secures the control console assembly to your range, keeping the control board and interface stable. Replace if bracket is cracked, broken, or missing.

Burner won't heat or stuck on one temperature? This infinite switch controls your range surface element heat levels. DIY repair restores precise cooking.