Parts for Whirlpool WFW87HEDW1: 04 - Control Panel Parts

Replacement door handle for laundry center units. Installs on the front door panel. Needed when your existing handle is cracked, broken, or damaged.

Fix a washer that won't turn on or display lights with a new control panel. Resolves unresponsive touch controls and blank displays. Moderate DIY repair.

This is a gray plastic timer knob that attaches to the dryer's control panel shaft. It allows you to select and set the drying cycle and time. Replace this knob if it is cracked, broken, or if the D-shaped shaft hole is worn out, causing the knob to spin freely without engaging the timer.

This is a chrome-finished timer knob that attaches to the timer shaft on the dryer's control panel, allowing you to select and start drying cycles. It is made of plastic with a metallic chrome appearance. Replace this knob if it is cracked, broken, or no longer grips the timer shaft properly, making it difficult to turn or set the dryer cycle.

Mounting screw for laundry center assembly. Secures panels, components, and structural parts. Replace if stripped, rusted, or missing during repair.

Fix intermittent power, unresponsive controls, or component failures in your washer. This wire harness restores electrical connections between control and parts.

Replacement mounting bracket for washer models. Secures internal components in proper position. Order new bracket if original is cracked, bent, or broken.

This is a replacement screw designed to work with a wide range of household appliances. It is used for many purposes in these appliances, from holding body panels together to securing electronics into control boards. However, screws are subject to damage through corrosion, impact, and improper installation/removal. In most cases, the primary damage to this screw is through corrosion – it may become rusted or corroded in place, depending on the appliance and the maintenance provided during its lifespan. The screw may also be stripped or rounded due to improper removal or installation. If the screw is damaged, lost, or corroded in place, it will need to be replaced. In most cases, removal will require nothing more than a Phillips head screwdriver or the appropriately sized socket with a ratchet. However, if the screw is damaged, it may require a tap set to remove it from its mounting location. Note that this is a genuine OEM replacement screw made from durable, high-quality metal, and is sold individually. It fits Whirlpool, Maytag, Roper, Estate, Amana, Crosley, and Thermador appliances. It is used in over 150 machines, ranging from washers and dryers to air conditioners.

Washer stops mid-cycle or won't power on? A faulty wire harness disrupts electrical connections. This harness restores power flow for reliable operation.

Fix unresponsive controls or cycles that won't start with a new electronic control board. Restores proper cycle selection and timed operations.