Parts for Electrolux EI30BM55HZA: 05 - Control Panel,Soor,Misc. Parts

Fix a blank or flickering microwave display with this control board. Restores digital readout and touch controls. Moderate DIY repair, 30-45 minutes.

Replacement front panel for microwave control console. Restores worn, cracked, or faded exterior and secures control buttons and display assembly.

3mm x 8mm screw secures trim, panels, and brackets inside your microwave. Replace missing or stripped screws to restore proper fit and alignment.

Mounting screw for microwave panels, trim, and brackets. Replaces lost or damaged fasteners to restore secure alignment and eliminate rattles or loose components.

Replacement spring for microwave door latch mechanism. Restores return tension so the latch engages and releases correctly. Needed when spring is broken or worn.

Replacement trim frame for microwave door and control area. Restores outer appearance when original is cracked, chipped, warped, or bent. Direct-fit part.

Microwave door seal creates airtight closure for safe operation. Replace if torn, cracked, or loose to prevent microwave leaks. Verify fit with your model.

Hardware kit for mounting microwave to wall and cabinet. Includes screws, bolts, and washers for secure installation. Replaces lost or missing fasteners.

This is a paper or cardboard installation template used to mark mounting hole locations and cutout dimensions when installing the microwave. It ensures accurate placement of brackets and hardware on the wall or cabinet. Replace this template if the original was lost or damaged and you need to reinstall or relocate the microwave.

Wire rack for microwave ovens. Installs inside the cavity to provide an elevated cooking surface. Replace if bent, rusted, or missing from your unit.

Replacement wiring harness for microwaves. Connects electrical components inside the unit. Order if your harness is damaged, frayed, or melted.

Replacement mounting screw secures panels, trim, and components in microwaves. Needed when original screws are stripped, missing, or lost during repairs.

Replacement mounting screw that secures panels, trim, and internal components in microwaves and wall ovens. Needed when screws are stripped, missing, or lost.

Mounting screw for microwave installation and assembly. Replace missing, stripped, or damaged screws to secure panels and components properly.

A replacement unified-thread screw used to secure appliance panels and internal components. Provides a direct fastener to restore secure attachment when original screws are missing, damaged, or corroded. What it does:

• Fastens panels, brackets, trim pieces, and other appliance components that use a unified-thread screw.
• Restores secure mounting to reduce rattling, movement, or misalignment of parts.
• Replaces stripped, rusted, or missing screws to help maintain safe operation.
• Works where the appliance's service manual or parts diagram specifies a unified-thread fastening point.

• Disconnect power and water before servicing for safety.
• Use the correct screwdriver or bit to avoid stripping the head; install by hand until started, then snug—do not overtighten.
• Replace like-for-like: match thread type and length to the removed screw to ensure proper fit and function.
• If other fasteners show corrosion or damage, inspect nearby hardware and replace as needed.

Microwave mounting screw used to secure internal components or attach the unit to cabinets. Replace if screw is stripped, missing, or broken.

Replacement washer for your microwave. Installs between components to provide spacing or cushioning. Order a new one if the original is missing, worn, or damaged.