Parts for Ge AJCS10DCCW2: 02 - Control Parts

This cap clamp secures a wire terminal cap or boot to appliance wiring, helping keep electrical connections stable and aligned for reliable component operation. It's a small but important retainer used where terminal caps are present. What it does:

• Holds a protective cap/boot onto a wire terminal so the cap won't slide off during use or vibration
• Helps prevent loose connections that can cause intermittent operation or arcing at the terminal
• Keeps wiring organized at terminal blocks and component connectors
• Useful when a worn or damaged retainer allows caps to shift or expose metal contacts

• Disconnect power to the appliance before inspecting or replacing wiring components
• Use needle-nose pliers to fit the clamp over the cap/terminal; avoid pinching wires
• After installation, restore power and verify the related component powers and operates normally

The Control Knob Assembly is an OEM part for GE air conditioners. This assembly allows users to adjust settings such as temperature, fan speed, and operational modes, providing precise control over the unit's performance.

Causes of a bad control knob assembly can include wear and tear from frequent use, accidental breakage, or internal component failure.

Symptoms of a bad Control Knob Assembly include:

• Difficulty turning or adjusting the knob
• The knob becoming loose or falling off
• Inconsistent or unresponsive changes in settings
• Visible cracks or damage to the knob

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Protect and refresh your control panel with this temperature control cover. It shields the temperature-control opening, supports the knob for smooth adjustments, and restores a clean appearance when the original cover is cracked or missing.

• Covers and protects the temperature/thermostat control opening on the control panel
• Provides proper seating and alignment for the control knob or dial
• Helps keep dust and debris out of the control cavity
• Common signs it's needed: broken, warped, or missing cover; wobbly knob; exposed controls

• Disconnect power before servicing
• Pull off the control knob; remove grille/trim as needed to access fasteners or tabs
• Remove the old cover; position and secure the new cover as designed
• Reinstall knob and panels; restore power and test control operation