Parts for Kenmore 596.9500910 (5969500910, 596 9500910): Control Parts

Internal tubing that carries water from the supply valve to various refrigerator components like ice makers and dispensers. Replace if you notice water leaks inside the refrigerator or reduced water flow to dispensers.

This tube union is a small pipe connector that joins two appliance tubes to maintain a sealed fluid or gas pathway. It replaces a worn or damaged connector to stop leaks and restore proper flow where a union is used. What it does:

• Joins two sections of tubing to create a sealed, removable connection
• Maintains proper flow in the appliance's plumbing or fuel lines
• Commonly replaced when a connection leaks or shows visible corrosion or damage
• Helps restore reliable operation of the system served by the tubing

• Turn off and isolate power, water, or gas supply before servicing; follow appliance safety instructions.
• Inspect tubing ends and fittings for damage; replace any compromised tubing or seals.
• Use proper tools and fittings; tighten to OEM torque and check for leaks after reassembly.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued and is no longer available.

This is a replacement screw designed to work with a wide range of household appliances. It is used for many purposes in these appliances, from holding body panels together to securing electronics into control boards. However, screws are subject to damage through corrosion, impact, and improper installation/removal. In most cases, the primary damage to this screw is through corrosion – it may become rusted or corroded in place, depending on the appliance and the maintenance provided during its lifespan. The screw may also be stripped or rounded due to improper removal or installation. If the screw is damaged, lost, or corroded in place, it will need to be replaced. In most cases, removal will require nothing more than a Phillips head screwdriver or the appropriately sized socket with a ratchet. However, if the screw is damaged, it may require a tap set to remove it from its mounting location. Note that this is a genuine OEM replacement screw made from durable, high-quality metal, and is sold individually. It fits Whirlpool, Maytag, Roper, Estate, Amana, Crosley, and Thermador appliances. It is used in over 150 machines, ranging from washers and dryers to air conditioners.

This part has been discontinued and is no longer available.

White refrigerator kickpanel / toe grill. Mounting clips sold separately. For mounting clips order two of WPM0117303.

Clips not included. For clips order WPM0117303

Water pooling in freezer or fridge? A clogged or cracked defrost drain funnel causes leaks. DIY fix in 30-45 minutes by accessing the rear freezer panel.

This part has been discontinued and is no longer available.

This red thermistor is a temperature-sensing replacement that helps the oven control read interior temperatures accurately so cooking cycles run as expected. It's a direct-fit sensing probe used in the oven cavity. What it does

• Measures oven temperature and sends the signal to the control board
• Can help resolve symptoms like inaccurate oven temperatures or uneven cooking
• Faulty thermistors may cause the oven to run too hot, too cold, or trigger temperature errors
• Works as the temperature feedback component for bake/broil control systems

• One red thermistor sensor

• Disconnect power to the appliance before beginning any repair
• Located inside the oven cavity (usually on a side or rear wall); remove access screws or panels as needed
• Handle the sensor and its wiring harness gently to avoid damage