Parts for Ge CVM521P2M1S1: Control Parts

This control panel bracket secures the range/oven front control panel and supports its components for stable operation and proper alignment. It helps restore a loose, sagging or improperly aligned panel after damage or wear. What it does:

• Provides structural support for the front/control panel and attached controls
• Keeps the control panel aligned to prevent rubbing or gaps
• Secures the control assembly so buttons and knobs operate reliably
• Commonly replaced when the panel is cracked, bent, loose or mounting points are broken

• One control panel support bracket

• Disconnect power to the appliance before beginning any work to avoid shock
• Typical service requires removing the control panel/console and possibly backguard screws
• Keep all fasteners and wiring secure; inspect nearby clips and mounts for additional damage

This wire harness assembly routes low- and high-voltage connections between the appliance's control and its components, restoring reliable electrical connection for proper operation and safe power delivery. What it does

• Provides a bundled set of insulated wires and connectors to link controls, sensors, and motors
• Replaces damaged or burnt wiring that can cause intermittent operation or a non-functioning component
• Ensures correct connector fit and routing to prevent arcing or short circuits
• Helps restore proper signaling between control boards and field components when original harness is faulty

• Always disconnect power at the breaker or unplug the appliance before service
• Inspect mating connectors and terminals for damage; replace if corroded or melted
• Secure and strain-relieve the harness to prevent pinching, chafing, or contact with hot surfaces