Parts for Lg LDE4415ST/00: Controller Parts

This is a truss-head tapping screw used to secure trim, panels, and small assemblies on compatible LG appliances. It provides a low-profile, wide-bearing head that helps hold parts flush and resist pull-through. What it does:

• Fastens plastic and sheet-metal components where a self-tapping thread is needed
• Truss head spreads load to prevent damage to soft or thin materials
• Helps secure control panels, brackets, or trim pieces that require a low-profile head
• Common replacement when original mounting screws are missing, stripped, or corroded

• One truss-head tapping screw

• Use the correct screwdriver bit and moderate torque to avoid stripping the screw or workpiece
• Start threading straight and let the screw form threads without forcing at an angle
• Disconnect power and follow appliance-specific service safety procedures before working internally
• Replace any damaged mating threads or clips for a secure fit

Insulator pad for electric and gas ranges. Protects components from heat damage. Replace if cracked, deteriorated, or missing to maintain proper insulation.

Clear viewing pane for range oven doors. Replace when cracked, shattered, chipped, or stained to restore visibility and a clean, finished appearance.

Outer door glass and stainless steel panel assembly for your range oven. Replaces cracked, broken, or damaged glass and trim on the lower door.

Replacement door frame for electric and gas range ovens. Replace this structural component if cracked, bent, or damaged to restore door appearance.

Decorative panel for your range oven door. Installs on the exterior door surface to refresh appearance. Replace if cracked, chipped, or discolored.

The inner cover protects internal components and wiring by covering the appliance's cabinet opening, helping prevent debris entry and accidental contact. It restores safe access and maintains the appliance's internal layout and airflow. What it does

• Shields internal electronics, wiring and assemblies from dust and debris
• Helps prevent accidental contact with energized components
• Restores proper internal clearance and part alignment after repair
• Can address symptoms like visible damage, exposed wiring, burning odor or intermittent operation caused by a compromised cover

• Replace with power disconnected and appliance unplugged to avoid shock
• Verify correct orientation and secure all mounting tabs/screws; do not force into place
• Inspect adjacent wiring and components for damage while the cover is removed
• Use only the part number shown for exact fit

Secures and pivots your range door smoothly. Replace when doors drift, rub, or won't align properly. Confirm fit with your model number before ordering.

Shield plate for electric and gas ranges. Protects internal components from heat and debris. Replace if cracked, bent, damaged, or missing for proper range operation.