Parts for Lg LRE3083ST: Controller Parts

This part is an oven control board. It's manufactured by LG. The oven control board includes the display that shows the time, temperature, and oven functions. It is designed to be durable, but can short out because of a power surge. The control board can also be damaged through exposure to moisture or high heat, and through physical impact.Replacing the oven control board will require turning off the power to the oven and removing the metal cowl that covers and protects the board. Take note of the wire harness positions on the board. Remove the wiring clips, unscrew the mounting screws, and remove the old board.This genuine OEM part is sold individually. It is only designed to work with LG ovens.

This single wire harness connects controls and components to deliver power and signals so affected functions run correctly. It replaces a damaged harness to restore reliable electrical connections and consistent operation. What it does:

• Transfers power and control signals between the control board and individual components
• Restores missing or intermittent power to components when a harness is damaged
• Prevents shorts and poor connections caused by frayed wires or broken terminals
• Typical symptom: appliance or specific functions do not power up, run intermittently, or behave erratically

• Disconnect power to the appliance before starting any work.
• Match connector shapes and wire colors; seat each connector fully until it clicks.
• Route the harness following existing clips and retainers to avoid chafing or pinching.
• If terminals are corroded or connectors are damaged, replace the harness rather than attempting repairs.

This single wiring harness connects electrical components to restore reliable power and signal routing within the appliance. It replaces damaged or burnt harnesses to help return normal operation and prevent intermittent faults. What it does

• Routes power and signal between control boards, sensors, and motors for proper operation
• Replaces frayed or melted wiring that can cause intermittent function or component failures
• Helps resolve symptoms like no power to a component, intermittent operation, or error codes related to open circuits
• Restores factory wiring organization and secure connector fit for reliable connections

• One wiring harness assembly

• Disconnect power before servicing to avoid shock or damage
• Verify connector orientation and fully seat all plugs; do not force connectors
• Replace only with the exact harness to maintain correct wire lengths and connector types

This is a manufacturer-supplied parts assembly that replaces a missing or damaged group of small components for your appliance, helping restore proper fit and function in the affected area.

• Provides the correct matched set of small components specified for your model's assembly
• Helps resolve issues caused by missing, worn, or damaged hardware and fittings
• Restores secure mounting, alignment, and reliable operation of the related section
• Exact-match replacement when used per your model's parts diagram

• Disconnect power (and shut off gas/water, if applicable) before service
• Refer to your model's exploded-view diagram to confirm locations and orientation
• Transfer components in the same order/positions; avoid overtightening fasteners
• Inspect for sharp edges; use appropriate hand tools and test operation before restoring power

A circular lug designed to join a stripped wire to a threaded terminal for a secure electrical connection. Helps restore reliable contact at terminals and reduces the chance of intermittent power or arcing at connection points. What it does:

• Provides a strong mechanical and electrical connection between a wire and a screw or bolt terminal.
• Helps prevent loose connections that can cause intermittent operation, sparking, or overheating.
• Commonly used where a ring-style termination is required for safe, stable wiring.
• Works with properly sized wire and fasteners to maintain consistent conductivity.

• Always disconnect power to the appliance before inspecting or replacing electrical parts.
• Use the correct lug size and gauge for the wire and terminal; crimp or solder per manufacturer recommendations.
• Tighten terminal hardware to the appliance manufacturer's specified torque; avoid over-tightening which can damage the lug or terminal.
• If wiring insulation or the terminal is damaged or corroded, replace the affected components rather than reusing them.