Parts for Briggs & Stratton 135202-0615-A1: Controls 2 Parts

This governor control rod is a genuine OEM replacement part for a number of small gas-powered engines. A governor acts as a sort of cruise control for an engine, helping it to maintain a constant output no matter the workload. Without a governor, an engine would lag out as workload increases if the operator does not manually increase the amount of fuel injected into the engine. This rod acts as a control for the governor. Governors are usually located near the heart of the engine and are not susceptible to much physical damage. However, over time they can wear out. Before attempting this repair, allow the engine to cool completely and drain it of any excess fuel. This is a high-quality part sourced from its original manufacturer and it is compatible with mowers, blowers, generators, splitters, and chippers made by Toro, Craftsman, Briggs & Stratton, Simplicity, and Cub Cadet. This part ships individually.

Control wire casing for lawn and garden engines. Protects and guides throttle or choke control cables. Replace if cracked, split, or missing.

Control wire for lawn and garden engines. Connects controls to engine throttle or choke mechanisms. Replace if frayed, broken, kinked, or missing.

This is an authentic muffler deflector screw that is found in small engines for outdoor power equipment from Briggs & Stratton. This metal screw is designed to secure the muffler deflector to the flywheel. In select models, it may also be used to secure the starter clutch to the flywheel. The screw is durable but exposed to high heat and constant wear, which means that it can become damaged or worn with regular use. If the screw is lost or damaged, it will need to be replaced. It should always be replaced with a genuine OEM part. This OEM muffler deflector screw is manufactured by Briggs & Stratton to exact standards and is compatible with several models of small engines. It can be used with various models of blowers, pressure washers, generators, and snow throwers from Toro, Murray, and Briggs & Stratton. It is sold as an individual replacement part. To replace this screw, the flywheel cover will need to be removed. Then, if it is still present, the old screw will need to be removed and the new one can be installed. This screw requires a hex or Torx screwdriver to install. Always wear gloves and disconnect the spark plug for safety when performing engine repairs.

The bell crank link is a genuine OEM replacement part designed for use with certain small engines in lawn and garden equipment. Also commonly used in automotive engines, this metal link is used to connect the throttle to the carburetor and assist in controlling the speed of the engine. Over time, the link can become worn or break entirely with regular use, since it is exposed to constant vibrations and repetitive motion. When the link breaks or malfunctions, the engine will not run properly and there will be no throttle control. That requires a full replacement, which is easier than attempting a repair on a bell crank link. This genuine bell crank link is manufactured by Briggs & Stratton and designed for use on hundreds of engines for lawn and garden equipment. It can be used on lawn tractors, mowers, and other compatible units. The item is made from premium metal and requires a wrench, pliers, and a hex key to replace. Be sure the engine is cool and wear gloves during repairs to protect the hands. This unit is sold as a single item and does not include any additional components or hardware.