Parts for Ge GFD85GSSN1WW: Controls & Backsplash Parts

Fix a dryer with no display, unresponsive buttons, or cycles stopping early. This user interface control board restores console function. Moderate DIY.

This bracket secures the power/start button to the appliance control panel so the button stays aligned and functions correctly. Replacing a damaged bracket restores proper button fit and reliable user control. What it does:

• Holds the power/start button in place inside the control panel assembly.
• Keeps the button aligned so presses engage the switch consistently.
• Prevents the button from rattling, sticking, or falling out of the panel.
• Used when the button housing is cracked, bent, or missing mounting support.

• Disconnect power to the appliance before beginning any work.
• Remove the control panel trim or fascia to access the bracket; keep screws and fasteners organized.
• Handle internal components gently to avoid damaging the button, switch, or wiring.

8-18 hi/lo 5/8

The Handle Facia IMD and Badge Holder is an OEM part for GE dryers. It serves as the facia on the outside of the dryer door, housing important graphics and model identification. This part also acts as the secure backing and holder for the dryer badge bearing the brand name and additional details.

Causes of a bad handle facia IMD and badge holder can include cracks, breaks, or loose fittings that no longer securely hold the badge in place. 

Symptoms of a bad part include:

• Faded or worn graphics and text that are difficult to read  
• Loose or detached badge that no longer stays firmly in place
• Cracked, broken, or deteriorated facia material
• Warped or misshapen facia that no longer fits properly on the dryer door

This genuine GE replacement part is also compatible with some Roper, Hotpoint, and Kenmore dryer models.

The GE Badge is an OEM part for GE washing machines. It is an emblem installed on the exterior of the washer that identifies the manufacturer and brand. Beyond aesthetics, the badge also demonstrates authenticity and quality assurance for the appliance.

Causes of a bad badge can include damage from impact or weathering over time, loss of adhesion to the outer casing, or fading/wear of printed graphics.  

Symptoms of a bad badge include:

• Missing or loose badge that is no longer securely attached
• Faded or illegible print that fails to display the brand
• Cracks or pieces breaking off the badge surface

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Size: 8 - 18 ab.

10-32 hex-washer head screw secures panels, brackets, and internal components in dryers and washers. Replace worn, stripped, or missing hardware.