Parts for Frigidaire GAS18EW2A2: 03 - Controls Parts

A small metal mounting screw used to secure appliance panels and internal components. Simple replacement that restores proper fit and reduces rattling or loose parts when the original fastener is missing or damaged. What it does

• Secures panels, brackets, or trim pieces to the appliance chassis
• Holds internal components in place to maintain alignment and function
• Helps prevent vibration noise and movement from loose parts
• Suitable where the OEM listed screw size and thread match the original

• Disconnect power and water before servicing
• Use the correct screwdriver or driver bit to avoid stripping the head
• Start threads by hand to prevent cross-threading; tighten until snug—do not overtighten
• Keep any removed screws organized to ensure correct reassembly

This metal mounting strap secures the refrigerator/freezer start/run capacitor to the cabinet or compressor assembly, helping keep the capacitor stable and preventing vibration damage. It's a direct-fit replacement for a damaged or missing strap. What it does:

• Holds the capacitor firmly in place to prevent movement and vibration
• Helps stop rattling noises caused by a loose capacitor
• Protects wiring and terminals from contact and wear due to shifting components
• Restores proper component positioning after corrosion, breakage, or prior removal

• Disconnect power to the appliance before starting any work
• Handle the capacitor and wiring carefully; avoid pulling on leads
• If the capacitor was recently in use, allow time to discharge or follow safe discharge procedures before touching terminals
• Use appropriate fasteners and torque to secure the strap without crushing the capacitor

A small metal mounting screw used to secure appliance panels and internal components. Simple replacement that restores proper fit and reduces rattling or loose parts when the original fastener is missing or damaged. What it does

• Secures panels, brackets, or trim pieces to the appliance chassis
• Holds internal components in place to maintain alignment and function
• Helps prevent vibration noise and movement from loose parts
• Suitable where the OEM listed screw size and thread match the original

• Disconnect power and water before servicing
• Use the correct screwdriver or driver bit to avoid stripping the head
• Start threads by hand to prevent cross-threading; tighten until snug—do not overtighten
• Keep any removed screws organized to ensure correct reassembly