Parts for Frigidaire GLEC30S8ES1: 03 - Controls Parts

The Control Knob is an OEM replacement part for Frigidaire ranges and cooktops. It measures about 2-1/2 inches in diameter. It allows users to control the heat settings for burners or the oven, ensuring precise temperature adjustments during cooking. The knob is designed to fit securely onto the control shaft, providing a user-friendly interface for operating the appliance.

Over time, control knobs can wear out or become damaged due to repeated use, accidental impacts, or exposure to high temperatures. A broken or malfunctioning knob can make it difficult to adjust or control the appliance effectively.

Symptoms of a bad control knob include:

• Difficulty turning the knob or it spinning freely without engaging
• Cracks, breaks, or visible damage to the knob
• The appliance not responding to adjustments made with the knob
• The knob not staying securely attached to the control shaft

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

A small sleeve used to support and align a shaft, pin, or lever inside the appliance. Replacing a worn bushing restores smooth, quiet movement and helps prevent accelerated wear on adjoining parts for reliable operation. What it does:

• Supports and centers a rotating or sliding shaft/pin
• Reduces friction and metal-to-metal wear to minimize noise
• Helps maintain proper alignment for consistent performance
• Common signs of wear: wobbling play, squeaks/grinding, binding, or visible cracks

• One bushing

• Disconnect power and shut off gas/water before servicing
• Note the original orientation; seat the new bushing fully and squarely
• Clean mating surfaces; inspect shafts/pins for wear and replace if damaged
• Apply manufacturer-approved lubricant only if specified by your service manual

This electrical switch restores reliable on/off control to the designated circuit in your appliance. Replacing a worn or stuck switch helps ensure lights, fans, or motors operate only when they should. What it does

• Opens and closes an electrical circuit when actuated
• Helps correct issues like a light that won't turn on/off or a component that won't run or won't stop running
• Resolves intermittent operation caused by worn contacts or a loose/broken actuator
• Addresses signs such as melted/discolored terminals or an unusually loose/tight switch feel

• 1 switch

• Disconnect power to the appliance before servicing (unplug or switch off the circuit breaker)
• Access the switch location per your model's service information
• Photograph wire positions and transfer connectors one at a time to the new switch; do not force terminals
• Secure the switch, reassemble, restore power, and test operation

The Surface Element Switch is an OEM part for Frigidaire electric cooktops and ranges. It is an electronic component that controls the power supply to individual cooking elements on the surface.

Causes can be normal wear and tear over time, exposure to moisture, food spills or other contaminants on the cooktop. Physical damage from impacts could also cause switch failure.

Symptoms of a bad surface element switch include:

• Elements failing to heat up or staying hot even when controls are set to off
• Inconsistent or intermittent power to surface elements
• Loose, cracked, or non-responsive switches

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.