Parts for Ge DBL333GB0CC: 01 - Controls & Top Panel Parts

This Rotary Start Switch is an OEM replacement part for GE dryers It is responsible for initiating the dryer's operation when the user turns the knob to the desired cycle and presses the start button. The rotary start switch is typically located on the control panel of the dryer, where the user interacts with the various settings and functions.
The GE dryer rotary start switch can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.

This part fixes the following symptoms:

• The dryer not starting or responding when the start button is pressed
• The start button feeling loose or not engaging properly
• The dryer starts intermittently or only when the start button is held down
• The dryer starts but immediately stops once the start button is released
• The start switch becomes unresponsive or difficult to turn
• The dryer not cycling through the different drying modes or settings

8 - 32 x 1/4

8 - 18 x 0.31

The Selector Knob is an OEM part for GE washing machines. This knob is used to choose different wash cycles and settings on the control panel, allowing users to customize their laundry preferences. It is designed to fit securely onto the control shaft and provide smooth operation for selecting various options.

Over time, selector knobs can wear out or become damaged due to frequent use or accidental impacts. Causes of a bad selector knob can include cracked or broken plastic, stripped or worn-out internal components, or a loose fit on the control shaft.

Symptoms of a bad selector knob include:

• Difficulty in turning the knob or selecting settings
• Knob spinning freely without changing settings
• Knob falling off or feeling loose
• Visible cracks or damage on the knob

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This top panel replaces the outer cover above the cooktop control area to restore the appliance's finished appearance and protect internal components from spills and heat. It fits into the appliance's front top assembly for a secure finish. What it does:

• Covers and protects control assemblies and wiring from spills, grease, and heat exposure
• Restores a flush, finished look to the appliance front where the original panel was damaged or corroded
• Helps prevent debris from entering internal components that can cause control issues
• Commonly replaced when the panel is dented, rusted, cracked, or has paint damage

• 1 top panel

• Disconnect power at the breaker or unplug the appliance before starting any work
• Remove control knobs and any trim pieces as required to access mounting screws; handle trim carefully to avoid scratching
• Support the top panel during removal and installation to avoid dropping or bending it

This timer is the electromechanical control that sequences a washer's wash, rinse and spin cycles, restoring proper cycle advancement and timing for affected machines. Use this direct-fit replacement to regain reliable cycle control and predictable operation. What it does:

• Rotates through and switches washer cycle stages (fill, agitate, drain, spin) to control timing
• Replaces a worn or failed timer that causes cycles to stop, not advance, or skip functions
• Restores timed operation when a washer won't complete cycles or starts intermittently
• Interfaces with controls and motors to coordinate cycle transitions

• Disconnect power before attempting service to avoid shock or injury
• Access may require removing the control panel or console
• Retain all mounting hardware and note wiring positions; replace exactly as removed