Parts for Ge DPGT750EC0PL: 01 - Controls & Top Panel Parts

This control panel assembly replaces a damaged or worn right-side console section to restore button access and the front-facing control surface. It provides the visible panel and button openings so controls operate and look correct. What it does:

• Replaces a cracked, faded, or broken right-side control panel section
• Restores proper button alignment and access for the right-side controls
• Helps stop debris or moisture from entering the front console area
• Addresses symptoms such as unresponsive or physically damaged right-side buttons, broken panel surface, or cosmetic wear

• Disconnect power to the appliance before starting any repair to avoid shock.
• Removal typically requires accessing the console area and removing fasteners; keep track of screws and small parts.
• Handle the panel carefully to avoid scratching the finish or damaging button openings; use soft tools to pry clips.

This display assembly powers and visually reports the appliance control status so you can see settings and feedback on the control panel. It restores readable on-screen information and enables the front-panel display functions. What it does:

• Replaces the control-panel LCD and power/display electronics so the screen lights and shows information again
• Commonly used when the display is blank, dim, flickering or showing garbled characters
• Resolves unresponsive or intermittent front-panel display behavior tied to the display module
• Interfaces with the main control board to present time, temperature, and mode/status readouts

• One complete display assembly (power/LCD) as shown

• Disconnect power to the appliance before beginning any work to avoid shock
• Handle the LCD and cable connectors carefully to avoid damage; flexing or scratches can affect operation
• Access typically requires removing the control console or console bezel—keep track of screws and fasteners
• If symptoms persist after replacement, test the main control board and wiring harness for faults

This side vent kit restores a finished side vent opening and directs exhaust airflow for proper ventilation. It replaces damaged or missing vent trim to help reduce drafts and visible gaps around the vent. What it does:

• Provides the exterior vent trim and mounting interface so the appliance exhaust vents cleanly to the side
• Restores a finished appearance where the vent exits the cabinet or wall
• Helps stop outside air from entering through a damaged or missing vent opening
• Can reduce rattling or noisy airflow caused by loose or broken vent trim

• Disconnect power to the appliance before attempting service and follow all safety guidelines
• Basic hand tools are typically needed; follow the appliance's service manual for specific instructions
• Use the OEM installation instructions and hardware
• Check the vent path and seal after installation to ensure proper airflow and fit