Parts for Ge PGD29BYTCFS: Convertible Drawer Parts

LED light assembly for refrigerator convertible or freezer drawer compartments. Replaces cracked, broken, or non-illuminating drawer lights.

Replacement fastener for refrigerator door handles. Secures handle to door with durable metal construction. Needed when original is cracked or broken.

Refrigerator convertible drawer gasket seals drawer to prevent air leaks and temperature loss. Replace if torn, cracked, or not sealing properly.

Left-side mounting bracket for convertible drawer in bottom-mount refrigerators. Replaces cracked, broken, or missing brackets that fail to secure drawer.

Right-side bracket for convertible drawer assembly in bottom-mount refrigerators. Replaces cracked, broken, or missing brackets that no longer secure drawer.

Drawer won't change temperature modes or respond to settings? This convertible drawer control board restores all four mode selections and temperature control.

Screw that secures the convertible drawer bracket inside your bottom-mount refrigerator. Replace if missing, stripped, or damaged during maintenance.

This set screw secures refrigerator components—most commonly door handles—to their mounting studs. Replacing a missing or stripped screw restores a solid, secure feel and helps prevent loose or wobbly handles.

• Locks the handle to its mounting stud to keep it tight and secure
• Helps resolve a loose, wobbly, sliding, or rattling handle
• Replaces a missing, rounded, or damaged set screw
• Helps maintain proper handle alignment and consistent door operation

• Unplug the appliance or switch off power before servicing
• Ensure the handle is fully seated on the studs before tightening
• Start the screw by hand to avoid cross-threading; then tighten until snug
• Do not overtighten to prevent stripping the screw or handle threads

A replacement stainless drawer handle with integrated profile badge that restores the look and grip of your appliance drawer. Designed to match the original handle styling and provide a secure pull for everyday use. What it does:

• Replaces a cracked, bent or worn drawer handle to restore normal opening and closing.
• Restores original appearance on stainless fronts where the profile badge is visible.
• Provides a durable, easy-to-grip pull for drawers and lower freezer compartments.
• Helps eliminate loose or wobbly handles caused by stripped or damaged pulls.

• Remove drawer contents and open drawer fully before starting.
• Use the correct screwdriver or bit for the mounting screws; do not overtighten to avoid stripping.
• Keep original mounting hardware; verify included hardware before installation and replace if missing or damaged.

M6-1.0 x 16mm mounting screw for bottom-mount refrigerators. Secures panels, brackets, and components. Replace when stripped, missing, or damaged.