Parts for Bosch NET8666UC/01: Cooktop Assembly Parts

This glass-ceramic hob top replaces a damaged or worn cooktop surface, restoring a smooth, heat-resistant work area for your range. It provides an even surface for burners and helps keep the cooktop looking clean. What it does:

• Replaces cracked, scratched, or pitted glass-ceramic cooktop surfaces
• Restores a level, heat-resistant surface for proper cookware contact
• Helps prevent heat damage and improves ease of cleaning
• Addresses symptoms like visible cracks, chips, or uneven heating areas

• Includes: 1 glass-ceramic hob top

• Disconnect power to the range before starting any work and verify the appliance is fully de-energized
• Handle glass carefully—wear cut-resistant gloves and eye protection to avoid injury
• Installation may require removing burner components and trim; only install if the part number and mounting layout match your appliance

This main control module manages a dishwasher's cycles and user interface, restoring proper operation when the electronic control fails. It replaces a failed control board to help the appliance respond to commands and complete wash programs. What it does:

• Controls cycle selection, timing, and sequence for wash and drain operations
• Processes commands from the touchpad or buttons and runs the display/indicators
• Can resolve symptoms like dishwasher not starting, unresponsive controls, or interrupted cycles
• May clear or prevent error-code-driven shutdowns when replaced with a known-good board

• Disconnect power (unplug or switch off breaker) before starting any repair
• Remove the access panel to reach the control housing; keep screws and fasteners organized
• Handle the board by its edges and avoid static discharge—use an anti-static wrist strap if available

This heating element heats dishwasher wash and rinse water and helps enable proper drying and sanitizing cycles. It restores the unit's ability to reach and maintain appropriate wash temperatures for cleaning performance. What it does:

• Warms wash and rinse water so detergents and sanitizing cycles work effectively
• Supports drying performance by raising internal temperature during final cycles
• Stops producing heat when the element is burned out, causing poor cleaning or no drying
• Can cause error codes or interrupted cycles if the element or its connections fail

• One heating element assembly

• Disconnect electrical power and water supply before servicing
• Handle the element and ceramic insulators carefully to avoid damage
• Verify correct fit and connection orientation for your model; secure wiring and seals

This heating element assembly provides the heating source for the appliance, restoring normal temperature output for drying/heating cycles. Replaces a worn or failed element to help recover proper operation and cycle performance. What it does

• Heats air or water as part of the appliance's main heating circuit.
• Restores normal cycle temperatures when the original element has failed.
• Can resolve symptoms such as no heat, extended cycle times, or temperature-related error codes.
• Works with the appliance's thermostat and safety cutouts to maintain safe operating temperature.

• Disconnect power (and gas supply, if applicable) before starting any repair.
• Handle with care to avoid damaging terminals, terminals insulation, or mounting brackets.
• Inspect surrounding wiring, connectors, and thermal cutouts; replace any damaged components.
• After installation, verify proper operation by running a test cycle and checking for correct heat and no unusual smells or noises.

A small chassis knockout protector that shields wiring and components where factory knockout holes are removed. Helps prevent wire abrasion and keeps openings tidy for safe appliance operation. What it does:

• Fits into a chassis knockout to protect wiring from sharp sheet-metal edges
• Helps prevent cable chafing and short circuits by covering exposed openings
• Keeps out debris while allowing routed harnesses to pass through the cabinet
• Commonly used where service or modifications require a sealed knockout

• One chassis knockout protector

• Install by pressing the protector into the knockout until it seats securely
• Ensure wiring is routed through the protector and not pinched between metal edges
• Disconnect power before servicing appliance to avoid shock or injury