Parts for Bosch HEI7052U/04: Cooktop & Control Panel Parts

Oven not heating or baking unevenly? This range heating element restores consistent cooking temperature. Straightforward repair for most DIYers.

This heating element heats air inside the dryer so laundry dries efficiently. It replaces a failed or damaged heating assembly to restore normal heat generation and drying performance. What it does:

• Produces the heat that dries clothes when the dryer runs
• Commonly related to no-heat or low-heat dryer symptoms
• Can fail open or short, causing intermittent heating or tripped breakers
• Works with the dryer's thermostat and thermistor to control operating temperature

• Disconnect power at the breaker before inspecting or replacing the element
• Handle with care to avoid damaging terminals or the element coil; wear gloves and eye protection
• Verify wiring placement and secure all fasteners; replace any damaged insulation or grommets

This is a replacement oven control board manufactured by Bosch. The oven control board is the oven's brain and handles all the functions. It also includes the display and provides users with the ability to control functionality, like bake and broil, setting timers, and more. While the oven control board does not include moving parts, heat and moisture can damage soldered components and lead to failure. Signs that the control board may need to be replaced include lack of information on the display, inability to control specific functions, or complete lack of operability. Note that this part is often misdiagnosed, so make sure to check the old board's operability with a multimeter before replacing it. To replace the oven control board, first remove the exterior cowling. Locate the wiring harness and disconnect it before removing the mounting screws. Install the replacement part following these steps in reverse.This genuine OEM part is sold individually. It only fits Bosch Thermador ovens.

This pushbutton switch controls power to the appliance circuit. When pressed, it opens or closes the electrical path to turn the function on or off, restoring reliable button response and consistent operation.

• Controls on/off power for the selected function
• Worn or stuck switch can cause no response when pressing the button
• Intermittent, delayed, or stuck-on operation may indicate switch failure
• Physical damage or heat discoloration on terminals are common failure signs

• Disconnect power before service to avoid electrical shock
• Note wire positions or photograph connections before removal
• Transfer wires firmly to the new switch; ensure terminals are fully seated
• Test function before reassembling panels

If your range controls aren't responding or the heating element won't turn on, this push-button switch restores reliable front-panel operation.

Replaces cracked or damaged control panel glass on your range. Installs on the console to protect buttons and displays while restoring appearance.

Rubber grommet cushions and seals range components, reducing vibration and protecting wiring. Replace when cracked, torn, or loose. Confirm fit with model.

Cracked, loose, or faded selector knob making it hard to switch oven functions? This range selector knob restores reliable control and clear settings.

Decorative trim plate for ranges. Installs around controls or edges to cover gaps and provide a finished look. Replace if cracked, chipped, or missing.

This sealing ring creates a watertight seal in the dishwasher pump/motor area to help prevent leaks and protect the motor assembly. It's a small but essential replacement for worn or damaged seals. What it does:

• Seals pump housing joints to stop water leaks beneath the dishwasher
• Helps maintain proper water pressure and circulation for cleaning performance
• Prevents water from reaching the motor and electronics, reducing risk of damage
• Replaces brittle, cracked, or flattened seals that commonly cause under-unit leaks

• One sealing ring

• Turn off power and water to the appliance before starting any repair
• Inspect mating surfaces and clean away debris or buildup before installing the new ring
• Lubricate the seal lightly with OEM-recommended lubricant or a thin film of water if needed to ease installation
• If multiple seals or gaskets show wear, replace them together to ensure a complete seal.