Parts for Bosch NET9652UC/01: Cooktop Parts

Seals the gap between your cooktop and countertop to prevent spills from leaking underneath. Replace when cracked, loose, or worn to maintain protection.

Fix error messages and unresponsive controls with this cooktop control module. Requires removing unit from cabinet and lifting cooktop. Moderate skill.

This is a radiant hilight hotplate element used in electric cooktops. It provides heat to the glass cooking surface for boiling, frying, and general stovetop cooking. Replace this element if a burner zone no longer heats up, heats unevenly, or fails to reach the correct temperature.

Burner not heating or taking too long to boil water? This heating element assembly restores proper temperature output. Common fix for cooktops and ranges.

Replace your cooktop heating element when a burner zone stops heating or heats unevenly. This radiant surface element restores proper cooking performance. Verify fit with your model number before ordering.

Burner not heating or heating unevenly? This hilight surface element restores radiant heat for cookware. Moderate DIY repair, about 30-45 minutes.

A small chassis knockout protector that shields wiring and components where factory knockout holes are removed. Helps prevent wire abrasion and keeps openings tidy for safe appliance operation. What it does:

• Fits into a chassis knockout to protect wiring from sharp sheet-metal edges
• Helps prevent cable chafing and short circuits by covering exposed openings
• Keeps out debris while allowing routed harnesses to pass through the cabinet
• Commonly used where service or modifications require a sealed knockout

• One chassis knockout protector

• Install by pressing the protector into the knockout until it seats securely
• Ensure wiring is routed through the protector and not pinched between metal edges
• Disconnect power before servicing appliance to avoid shock or injury

90-degree connector cable for ovens and cooktops. Replaces damaged, frayed, or missing connectors. Essential for secure electrical connections.

This is an insert component designed for use in a range vent hood. It fits into the hood housing to support proper airflow or provide a finished appearance on the unit's exterior. Replace this insert if it is damaged, warped, or missing, which can affect the fit and function of the vent hood.

Razor blade with cooktop cleaner

Replacement mounting hardware for electric cooktops. Includes screws, clips, and brackets to secure panels and trim. Needed when original hardware is missing, stripped, or damaged.

This cable harness routes power and signals between a major appliance control and its components so switches, sensors and motors can communicate and operate reliably. Replacing a damaged harness restores electrical continuity and component control. What it does

• Provides bundled wiring and connectors to link control boards with motors, valves, sensors and switches
• Replaces frayed, broken or burned wiring that can cause intermittent operation or complete failure of affected components
• Restores proper connector fit and secured electrical paths when original leads are loose or corroded
• Helps stop faults caused by shorted or open circuits when the harness is the damaged component

• Disconnect all power to the appliance before starting any repair.
• Compare the new harness to the old one for connector type, pin count and routing before installing.
• Route and secure wiring away from heat, sharp edges and moving parts; use original clips or ties when present.