Parts for Ge PHS930BL3TS: Cooktop Parts

This induction assembly replaces a damaged or nonworking induction surface element to restore induction heating on compatible cooktops. It provides the core induction coil and mounting needed for the element to generate heat for cookware. What it does:

• Houses the induction coil and associated hardware that create the electromagnetic field for induction cooking
• Restores heating when an induction zone fails to power or produce heat
• Resolves symptoms like no-heat, intermittent heating, or an induction zone that won't activate
• Works with the cooktop's control electronics to deliver localized heating to compatible cookware

• Disconnect power to the appliance at the breaker before servicing
• Handle the glass/ceramic surface carefully to avoid cracks or chips
• Reuse any verified mounting hardware; replace damaged fasteners as needed

Generator board assembly that produces the high-voltage spark used to ignite gas burners on compatible ranges and cooktops, helping restore reliable ignition and reduce continuous clicking or no-spark conditions. What it does:

• Generates the spark that lights surface burners and/or the oven burner on gas cooktops and ranges.
• Can stop or reduce continuous clicking with no ignition when the module fails.
• May cause one or more burners to stop sparking or ignite intermittently.
• Works with the range's ignition switches and electrode wires to coordinate safe ignition.

• Disconnect electrical power and shut off the gas supply before starting any work.
• Photograph or label wire locations before disconnecting to ensure correct reconnection.
• Handle the board and connector pins carefully to avoid damage; avoid touching components with bare hands or tools.

Cooktop won't turn on or has no power? A blown line fuse often causes complete electrical failure. This 20A fuse protects internal circuits from overloads.

Range blower not venting properly? This centrifugal blower restores proper ventilation. Direct replacement part for select electric range models.

Replacement cooktop glass surface for electric ranges. Restores flat, even finish when original is cracked, chipped, or scratched. Dark gray color.

This lower oven warming element heats the oven's warming/holding compartment so food stays warm until serving. Replaces a damaged or non-heating lower element to restore consistent low-temperature operation. What it does:

• Heats the oven's warming/lower compartment for holding cooked food
• Replaces elements that show visible damage, burn-through, or no heat output
• Helps restore even low-temperature performance when the warmer function fails
• Works with the oven's temperature control and safety circuits to provide steady heat

• One lower oven warming element

• Disconnect power at the breaker before beginning any repair
• Wear gloves; element edges and terminals may be sharp
• Verify proper wiring and secure terminal connections during installation

Element not heating or cooking unevenly? This induction element restores precise temperature control. Common repair for cracked or damaged elements.

The Rear Vent Trim and Gasket Assembly is an OEM part for GE ranges. It seals the rear vent opening of the range, directing hot air and potential gas fumes outside through the exhaust vent during oven use. Without an intact seal provided by the gasket and vent trim, combustion byproducts can enter the kitchen presenting safety and performance issues.

Causes of a bad range rear vent assembly include wear over years of use with high heat cycles, cracking or degradation of sealing materials, or damage from cleaning or impacts around the vent area.

Symptoms of an issue include:

• Foul odors detected in the kitchen during use of the oven
• Inefficient or uneven baking and broiling
• Visible openings or gaps seen around the rear vent perimeter
• Detached, cracked, or missing components

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Spacer for electric ranges. Installs to maintain proper clearance between components. Replace if cracked, worn, or missing to restore correct spacing.