Parts for Dacor ERSD30NG: Cooktop-Rev B Up Parts

This service regulator controls and stabilizes incoming natural gas pressure to the appliance, helping burners maintain reliable ignition and steady flame strength. It replaces a worn regulator to restore correct gas pressure regulation. What it does:

• Reduces and regulates incoming natural gas pressure to the 3–6 in. water column range for safe, consistent burner operation
• Helps restore proper ignition and steady flame when weak or uneven flames occur
• Prevents over- or under-pressurization that can cause poor heating performance
• Works as the pressure-regulating component in the appliance's gas supply system

• 1 service regulator

• Shut off gas supply and electrical power before beginning work
• After installation, perform a certified gas leak test and verify correct burner operation and pressure per manufacturer specs
• Do not attempt installation if you are not trained or certified to work on gas systems

This OEM part is sold individually and is a relay control board for ovens. An oven relay control board is a circuit board that receives signals from the main oven control board. The relay control board then relays the signal to regulate the oven's essential functions. If the oven is no longer turning on, heating properly, or regulating its temperature, it might be time for a new relay board. Luckily, replacing this part is not a difficult process.To replace the relay board make sure the oven is unplugged. Gain access to the upper back panel on the back of the range and remove the screws. Once the panel is removed access the relay board, and remove the wire harness as well as any individual wires attached to the old board. Make sure to take note of the orientation of the wires. Replug the wires into their correct terminals on the new board and snap the new board back in place. Resecure the upper back panel.This genuine replacement part is sold individually and is compatible with Samsung brand ovens.