Craftsman Wall Oven Parts

Fix an oven that won't heat or heats unevenly by replacing the lower bake element. Restores consistent baking temperatures. Takes 5-10 minutes to install.

Oven won't turn on or display is blank? This power control board supplies power to your range's electronic controls. Moderate DIY repair, 1-2 hours.

Controls gas supply pressure to burner manifold. Replace if regulator is cracked, sticking, or no longer maintaining correct pressure for consistent flames.

This convection ring element supplies the heat for the oven's convection bake and roast cycles. Replacing a failed element restores even convection performance so foods cook properly across multiple racks.

• Provides the heat source for convection modes; the fan circulates air across this ring for uniform baking
• Common symptoms of failure: no heat in convection, very long preheat, or uneven results during convection cycles
• Visual clues include cracks, blistering, or burn-through on the element band
• Electrical clue: element tests open/infinite (OL) with a multimeter when power is disconnected

• Disconnect power at the breaker before servicing; this is a high-wattage circuit
• Access varies by model: remove the rear panel or the interior convection cover to reach the element and terminals
• Note wire locations and transfer leads to the new element one at a time
• Ensure the element sits flat and does not contact the cavity walls; tighten mounting screws snugly

This control display board is the appliance's user-interface module that operates the front control panel and display, giving visible status and responding to user input. Replacing it fixes display and control issues safely and simply. What it does:

• Provides the visible display and interprets button/touch inputs so the appliance responds to selections.
• Can produce unresponsive or intermittent buttons/touch controls and erratic indicator lights.
• May trigger control errors or prevent cycle selection if damaged.

• Disconnect all power before starting — turn off breaker or unplug the appliance.
• Handle the board carefully and avoid static discharge; use a grounding strap if available.
• Remove and reattach wire connectors and mounting hardware gently; note connector orientation.
• Reconnect power and verify functions before reassembling trim or covers.

Burner won't adjust heat or jumps to full power? This infinite switch restores variable temperature control to surface burners. DIY install in 30 minutes.

This infinite switch controls the heat output of a surface burner element on an electric range by cycling power on and off at varying intervals. It allows you to select and maintain a specific temperature setting for the burner. Replace this switch if a burner stays on high regardless of the knob position, won't heat at all, or provides inconsistent temperatures.

This is a sealing gasket designed to create an airtight fit on an oven or range component such as a door or lamp glass assembly. It prevents heat from escaping and protects internal parts from moisture and debris. Replace this seal if you notice heat leaking from the oven, uneven cooking temperatures, or visible wear and cracking on the existing gasket.

This is the lower heating element located at the bottom of the oven cavity, responsible for producing heat during baking and roasting cycles. It is a round, looped metal element that glows red when functioning properly. Replace this element if the oven is not heating, heating unevenly, or if the element has visible damage such as blistering, breaks, or burn spots.

The grill heating element is a 230-volt, 1500-watt radiant coil or surface element that generates intense direct heat for grilling or broiling food in your range or cooktop. It glows red-hot to sear and brown food from above or below depending on its position. Replace this element if it no longer heats up, heats unevenly, has visible breaks or burn spots, or causes your circuit to trip when in use.