Parts for Craftsman 91760049: Crankcase Parts

This filter connect EMC (with caps) is the refrigerator water-filter connection assembly that secures the filter lines and provides a sealed connection to the filter housing. It helps restore a proper, leak-free connection for the water/filter interface. What it does:

• Connects the refrigerator water lines to the water filter housing for a secure seal
• Prevents water leakage at the filter connection when intact and properly installed
• Restores proper water flow to the dispenser/ice system when damaged or worn
• Useful when existing connection is cracked, loose, or missing protective caps

• Always shut off the refrigerator water supply before removing or installing the part
• Disconnect power to the appliance if required by your model before working near electrical components
• Inspect tubing and fittings for damage; replace any worn tubing or seals for a proper seal
• After installation, turn the water back on and check carefully for leaks; run water through the dispenser to clear air

This is an igniter and bracket assembly, and it is intended for use in dryers. This is a genuine replacement part made by Speed Queen. The igniter is connected to the dryer on the back of the appliance, and it is used to heat the drying tub. A new igniter

Fix a refrigerator that won't cool or runs intermittently by replacing a failed compressor starting relay. Essential for proper startup and cooling.

This replacement bottom case provides the appliance's lower structural housing, protecting internal components and helping maintain proper alignment. Durable molded construction restores support and helps contain minor drips for safer operation. What it does:

• Forms the appliance's lower housing to support internal parts and wiring
• Protects motor, pump and electronics from debris and contact
• Helps channel minor leaks away from controls and towards drain areas
• Restores proper fit and alignment of the appliance cabinet

• Disconnect power and water supply before beginning work
• Keep fasteners and clips organized; verify all seals and gaskets are seated during reassembly
• Inspect adjacent components (pump, hoses, wiring) for wear while unit is open